ROCK HARVEY's latest activity
-
I think I'll try the fishing string method and report back for both sets -
They also are supposed to each have the same degree total of bends (90 degrees = 2x45 degree bends) in addition to same length
-
You can get a temporary injection line that you could keep in your glovebox. https://www.accuratediesel.com/shop/250.html I suppose if...
-
ROCK HARVEY replied to the thread CDD injection line issues.That’s right, you need them all to be the same length because the high pressure pulse from the injection pump takes time to travel down...
-
Just a side note to this exact issue. I purchased a set of the china lines off amazon for $38 or so. They were so badly formed that I...
-
I appreciate the detailed response. I had called them up last Friday and the gentleman on the phone was adamant that the lines might be...
-
ROCK HARVEY replied to the thread CDD injection line issues.The problem was that the #1 line in my set was the same as my original line, but the rest were all significantly longer than the old...
-
ROCK HARVEY replied to the thread CDD injection line issues.I did eventually hear back, and they asked me to mail the lines back to them so they could check them. Unfortunately by then I had...
-
ROCK HARVEY reacted to MasterChiefIDI's post in the thread Valve Recession and Fel-Pro's head gasket.. with
Like.
Attached are my recessions and protrusion measurements. The others that have EX valves out have lower protrusion that I don't expect to... -
ROCK HARVEY replied to the thread Valve Recession and Fel-Pro's head gasket...Another option could be to get a head spacer shim. Rock Auto sells a .020 shim, SBI part #2302140. It’s out of stock right now...
-
ROCK HARVEY replied to the thread Valve Recession and Fel-Pro's head gasket...How much variation in valve recession do you have across all of them? When I did my heads I measured how deep all of my valves sat in...
-
ROCK HARVEY reacted to onetonjohn's post in the thread Doing oil cooler. Is this trick legit? with Like.
I used similar clamps. Hope I didn't cut it, but it didn't take a ton of force to assemble. Enough that I couldn't do it with body...
-
ROCK HARVEY reacted to onetonjohn's post in the thread Doing oil cooler. Is this trick legit? with Like.
Exhaust bolts came right out. Way easier with manifold gone. Thanks for the tip. Need to go get exhaust gasket and radiator hose...
-
ROCK HARVEY replied to the thread Doing oil cooler. Is this trick legit?.If you do end up doing it in the engine bay, I would buy a woodworking-style bar clamp in the right size and use that to squeeze them...
-
-
ROCK HARVEY replied to the thread Doing oil cooler. Is this trick legit?.I personally would not try it this way. It took a ton of force to get the assembly pressed together, and to me that seems much easier to...
