Recent content by RetiringColt

  1. RetiringColt

    Coolant leaking from...somewhere

    Maby I missed it but what psi is your new radiator cap rated for? I believe anything over 9psi is too high for these engines. Do you have a coolant Pressure tester or access to one? since you have a known leak, I'd suggest over pressurizing the system a few pounds to recreate your leak...
  2. RetiringColt

    Turbo setup ideas/

    Here's my go to . Ok, ok Just kidding. Sounds like you already know what you want. But why not use a turbo system that's already built for these engines?
  3. RetiringColt

    New turbo, no power

    Just my $.2 did you check to see if the harmonic balancer isn't slipping on the rubber dampener? I fought a timing issue on a gasser one time and it turned out to be the dampener spinning on it's self. It was fairly new too. Little over a year old. Marked it up with a paint pin and finally found...
  4. RetiringColt

    Coolant leaking from...somewhere

    If you're running green coolant you dont necessarily need to add the phosphorus die. Green coolant reflects pretty good with uv light and yellow glasses. Napa sells a basic leak detection kit for $18.00. This is a newer version of the one I used to use. Just take your time looking and don't rush...
  5. RetiringColt

    Cruise Control

    I vegly remember performing this recall way back when I worked at the stealership. But if you get used parts for your masters cylinder be sure to keep an eye out for leaks at the pressure switch.
  6. RetiringColt

    Alternator V-belt pulley slipping when swapping to 3G alt

    Here's a pic from the internet because I'm away from my truck, but you can see the two belts. Inside belt is for driving the alternator from the crankshaft and the outside belt is driving the vacuum pump from the alternator. Really only the inside belt drives the alternator. The outer belt is a...
  7. RetiringColt

    Flasher and turn signal relay locations on 1990 F250

    I've got a 89 quad cab. Both flashers are on the fuse panel under the dash. I've been chasing electrical issues since I got the truck. Water leak at the drivers windshield. Corroded the bulkhead connector. Fixed that. Starting relay harnesses on the steering column got hot and melted...
  8. RetiringColt

    Because winter's coming and (and there's no forum for other idi fords)

    I'm not real familiar with these engines. I thought that they were made by Perkins a division of Cat for Ford back in the 80's. I think 86 was the last year? Are you looking for a diagram/mechanical breakdown of the injection pump? In the video the pump looks like an older Bosch pump. Looks like...
  9. RetiringColt

    Cheapest oil I have found

    Bi-Mart has 2-1/2 gallon Dello 15w40 for $27.99. being a chain with their add posted on line I wouldn't think their price would very per store.
  10. RetiringColt

    sending units

    Good to know. T-Rex auto parts has had them available for a while now too. 85-07. front and back tanks too.
  11. RetiringColt

    Lift pump pressure and injection pump timing

    Thanks for the reply guys! Laserjock I noticed in those test results, most people were referring to a constant higher fuel pressure. I was thinking more along the lines of a variable pressure that increases with boost. I noticed that Macrobb recorded fuel pressure at idle of 4psi and dropped at...
  12. RetiringColt

    Friend or shop near Index, Wa.

    Selahadoor I'm about 4 hours away from you in washougal. I've recently acquired a timing pickup to work with my timing light. I'm not the most experienced, but it seemed to work on my truck. I work graveyard shift and am home during the day. I don't have a garage so it will be out in the...
  13. RetiringColt

    Lift pump pressure and injection pump timing

    Hello everyone. just had this rattling around in my head. I read about about an old McCulloch centrifugal supercharger installation and in it was a modification for the lift pump. They had put a hose port on the atmosphere orifice on the lift pump and routed it to the boost side of the...
  14. RetiringColt

    Promise... the build

    If your having trouble with steering geometry or vibrations/shimmying. And have checked all steering components. Don't forget to look at the bolts that hold the double I-beam to the frame. You probably would have to have the suspension unloaded and have a friend help to shake or jounce the tire...
  15. RetiringColt

    1986 6.9 fuel issues

    I'm running an eBay selector valve in my rig. it came with a new blade type connector. it was a direct fit for $68 plus tax and shipping. my old connector was broken. I just un-pinned the connector and installed the old pins into new connector. I tried to open the old selector and did get it...
See more

Latest posts

Forum statistics

Threads
91,283
Posts
1,129,783
Members
24,099
Latest member
IDIBronco86

Members online

Total: 872 (members: 9, guests: 863)

Share this page

Top