Recent content by redneck pride
-
doin up the cummins !
aint a lost cause any cummins is no lost cause!- redneck pride
- Post #2
- Forum: 5.9L 24 valve Cummins
-
injectors and tranny
ya ordered all suncoast and ddp 150s hopefully get started on er next weekend- redneck pride
- Post #3
- Forum: 5.9L 24 valve Cummins
-
injectors and tranny
alright its time to rebuild the tranny in the goat (again) I already got a billet triple disc converter built buy midwest converters, BD valvebody, all plastic replaced with aluminum, steel sealing rings instead of cork or rubber and a 48re overdrive sping, problem is I keep burning clutches up...- redneck pride
- Thread
- Replies: 2
- Forum: 5.9L 24 valve Cummins
-
nv4500 problems
Got a friend with a 97 12valve with a 5 speed and he can only get 2nd and 4th gear. 5th gear nut has been fixed, but were thinkin the bearings and synchros are bad cause its got bit more slop in it than it should have. ever now and then you can get 1st and 3rd but you can not get 5th or...- redneck pride
- Thread
- Replies: 0
- Forum: 5.9L 12 valve Cummins
-
48re problems - starts out in 2nd gear
If its a 99 it most likley doesnt have a 48 in it, it would have a 47re in it, and I had the same problems, change the governor solenoid and pressure sensor in the valve body, that solved my problem, mine was starting in second sometimes and other times it would start in 1st but skip 2nd and...- redneck pride
- Post #2
- Forum: 5.9L 24 valve Cummins
-
DT466
I think I should have mine done this winter but we'll see wat happens with work first- redneck pride
- Post #18
- Forum: 5.9L 24 valve Cummins
-
DT466
I aint got it in there yet that project got put on hold for a while I had to go back to work down in florida on the pipeline, but get back at er when I get back this fall- redneck pride
- Post #15
- Forum: 5.9L 24 valve Cummins
-
dnj governor solenoid
DNJ industries makes a governor setup that replaces the faulty dodge unit, it uses a gm solenoid witch can handle more fluid pressure and also deals with debris better if there are any in the fluid, symptoms of a bad governor: Hunts for the shift between 1st and 2nd and possibly other gears...- redneck pride
- Post #3
- Forum: 5.9L 24 valve Cummins
-
dnj governor solenoid
just got the tranny done and I got about 500 miles on it and now the governor solenoid is acting up, wondering I should go with another stocker or go with dnj 4le gm crossbread unit? thanks- redneck pride
- Thread
- Replies: 2
- Forum: 5.9L 24 valve Cummins
-
Cracked Exhaust manifold?
water **** will help lower egts and get some extra power to boot, i'd say you wana stay around the 1250 range to be safe, but if you go over it for a second or to you arent going to hurt anything, just dont do it for long periods of time- redneck pride
- Post #6
- Forum: 5.9L 24 valve Cummins
-
new truck
just watch those six speeds try to find a five speed (NV4500) they hold up alot better and dont forget about that clutch if you start bumping up the power, it wont take long she'll be slipping like mad! auto's arent bad if they are taken care of though.- redneck pride
- Post #4
- Forum: 5.9L 24 valve Cummins
-
Cracked Exhaust manifold?
check with ats on the manifold they might be cheaper and they are a 3 piece unit so that it wont crack again, Id be checkn that turbo and make sure nottin happined to that also, whoever had it must a had some high egt's coming out of it- redneck pride
- Post #2
- Forum: 5.9L 24 valve Cummins
-
new truck
My atuo just went out of my 00 1-ton but it was kinda my own fault (note to self dont do reverse burn outs!) but other than that its been alright if you dnt plan on going huge hp you'll be fine, but before you buy make sure you test drive it and make sure it doesnt slip, sticks are nice and they...- redneck pride
- Post #2
- Forum: 5.9L 24 valve Cummins
-
performance injectors
My mistake it was the front clutch housing that split and it split at the back side I'll try and post some pics of it soon kinda funny lookin, I got one I took out of another tranny so we'll see what happens tomorrow when I get er in there!- redneck pride
- Post #14
- Forum: 5.9L 24 valve Cummins
-
performance injectors
I found out why it lost reverse, the direct drive drum split in two peices so the trannys on hold untill I get that part, the kit from patc did come with valve body mods and 5 clutch power pack, looks like a good kit, thats some nasty carnage you got goin on there! would a 48re drum work in mine?- redneck pride
- Post #12
- Forum: 5.9L 24 valve Cummins
