MasterChiefIDI
Latest activity Postings About
-
-
MasterChiefIDI posted the thread 2026 Best Oil Filter for the 7.3 IDI? in 6.9L IH & 7.3L IDI Diesels.I was wanting to know what oil filter do you use for the 7.3 IDI? For reference, the factory FL784 filter was rated for like 30 Microns... -
MasterChiefIDI reacted to scsmith42's post in the thread Lip of sleeve at bottom of cylinder with
Like.
Guys, I used to own a machine shop and have personally installed a lot of sleeves. Yes, this method depicted by the OP is not uncommon... -
If it helps, you can mess up the hones down there as much as you like, so long as the are the piston rings travel is untouched.
-
MasterChiefIDI replied to the thread Lip of sleeve at bottom of cylinder.Thank you for your input. I have essentially arrived at the same conclusion after looking closer. I see in that diagram there's a step...
-
MasterChiefIDI reacted to jaluhn83's post in the thread Lip of sleeve at bottom of cylinder with Like.
Normal. Will have no significant impact on engine operation. No action required. It's one of 2 standard ways to ensure the sleeve...
-
MasterChiefIDI reacted to rreegg's post in the thread Pre combustion chamber crack advice with Like.
Godspeed, makes sense and for a truck you’ll have forever it’s the right call IMO. Love how these trucks are the opposite of disposable
-
MasterChiefIDI reacted to 8769bigred's post in the thread Pre combustion chamber crack advice with Like.
Just wanted to update this thread with my final decision for future readers. I got lucky and found a set of rusty heads locally here...
-
MasterChiefIDI replied to the thread CDD injection line issues.I thought this was interesting... from the AERA bulletin for the 7.3/6.9 pertaining to injection lines. "Injection lines - Due to the...
-
-
MasterChiefIDI replied to the thread Lip of sleeve at bottom of cylinder.Thank you for the feedback. This is terrible. I somehow missed it on pickup. This is the same machinist that messed up my first block...
-
MasterChiefIDI reacted to IDIBRONCO's post in the thread Lip of sleeve at bottom of cylinder with Like.
Maybe ask your machinist again. Show him the pictures. I don't know that this would contribute to piston slap since it's at the bottom...
-
Today I was assembling my motor when I noticed I have a somewhat sharp edge on 3 of my 8 sleeved cylinders. pressing a feeler next to...
-
-
MasterChiefIDI reacted to bulletpruf's post in the thread Comp 910-16 Springs and Valve Rotators? with Like.
Thanks. Actually gave Justin a call yesterday. He said intake may be a bit tight (slightly less than 1.800") but that's no big deal...
-
MasterChiefIDI reacted to Austin86250's post in the thread Comp 910-16 Springs and Valve Rotators? with Like.
a quote from justin at r and d " comp cams 910-16... you can set them to 1.800' height for ideal seat pressure, but dropping them in as...
-
MasterChiefIDI reacted to Olds64's post in the thread Help....Need a New Diesel Filler Neck for the MidShip/Side Tank with Like.
Do you need the rubber hose that goes between the fuel tank and filler neck? If so, this is the only place to get the right part...
-
MasterChiefIDI replied to the thread WARNING about King Main Thrust Bearings.Got my nos Clevite thrust bearings in today. They measure 3.322-3.323" so in spec! I plan to run these.
-
-
-
Loading…
-
Loading…
