Uni-matic U-joint tool

[texcl]

Have any of y'all seen this U-joint tool? I just bought it, it was made in 1960 I hope it'll work on my middle u-joint, in truck. Figured for $15 plus shipping I'd give it a shot......

You must be registered for see images attach

The claw is reversible for different sized u-joints.

 

[chris142]

Never seen one.buts its best to do all 3 joints at the same time. It only takes 10 minutes to pull the whole driveshaft.btw the slip yoke is keyed and will only go together 1 way

 

[FarmerFrank]

Looks like the smaller version of one I used on semi universals. It was always slick, couple hits with an impact and the caps would fall out.


Sent from my iPhone using Tapatalk

 

[texcl]

Yup hope it works well, I'm replacing the other u joint on the passenger drive shaft when I replace the ball joints in a couple weeks. I've replaced all the other u-joints already. Doing a lot of work on the old girl this month. Front axle work, new smf conversion, and oil cooler re-seal.

 

[79jasper]

Send it to me and I'll give it a whirl. Lol
Just kidding. I may need to have a new shaft built. Caps have been spinning.

Sent from my SAMSUNG-SM-G935A using Tapatalk

 

[texcl]

When I'm done with it, (if it works) I'll loan it out to forum,members here. Hopefully save someone some mullah. But that's putting the cart before the horse at this point.