I need to get ahold of you to figure out a price for an intake hat and some piping. I'm hoping to make some money before I take the job in Portland and get this IC installed.
i also need to figure the same if you are willing. i think i found an IC that a guy has sitting in his attic but not sure if hes gonna sell it to me. i desperately need an IC or at least water injection if i can't get that done.how much room is left behind the grill after the IC install? if i have two tranny coolers will is still fit? (they will be 1 inch thick at the most.)
The allthread is fine I need to run it down and lock it down with the lock nut you provided. and eliminate the jam nut I used on the top. Once I get my connectors I should be up and running in a couple of days.
We're thinking of dragging the Jeeps down to Hollister next month so I'll have a chance to load the camper with the Jeep and trailer and check the temps.
i am still turbo diesel dumb, the pics that Slade posted, is that a waste gated turbo or non waste gated? my factory turbo looks the same, but i don't know if it wasted gated or not..or if one is better than the other..
i am still turbo diesel dumb, the pics that Slade posted, is that a waste gated turbo or non waste gated? my factory turbo looks the same, but i don't know if it wasted gated or not..or if one is better than the other..
one pipe is ps, other was from a dodge I think and a 3 inch ebay tubing kit, my ic is an 00 ps with 6inches cut off the top. and the hat is a couple different pieces. After I get rid of the 6 I have I will tell. lol
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.