Disconnected tank selector, now no fuel gauge

[soggybottom]

I only have a front tank, so I bypassed my tank selector valve and removed it. Now my fuel gauge is pinned at full. Any way to remedy this without putting the valve back in?

 

[soggybottom]

Found this on line, and was wondering if I could make a jumper at the plug I removed from the selector valve?

http://jrohlf.web.cern.ch/jrohlf/fuel_tank_selector.pdf

 

[franklin2]

Go back to the selector wiring plug. Find the yellow/white wire, cut it and strip it. Then find the darkblue/yellow wire, cut it out and strip it also. Connect these two wires together and your gauge should start functioning again.

 

[soggybottom]

Boy, quick response. I'll give that a try in the morning. Thanks a million.

 

[79jasper]

The selector valve controls the gauge senders.......

 

[soggybottom]

Go back to the selector wiring plug. Find the yellow/white wire, cut it and strip it. Then find the darkblue/yellow wire, cut it out and strip it also. Connect these two wires together and your gauge should start functioning again.

Worked perfect. Thanks again.