Coyote_Red
Full Access Member
So I am considering having my factory turbo ceramic coated on the hot side as well as the up pipes, down pipe, and manifolds. Should I have it coated inside and out, or just outside. I have heard that coating just the outside will cause the material to fatigue and eventually crack due to not being able to dissipate heat that is now trapped in it. I am looking to keep underhood temperatures down for the most part, plus the performance boosts would be nice.
What about coating the outside of the compressor housing and intake to insulate it from underhood temps?
If you had this done what did it run?
Right now it is is a stock turbo engine with nothing else done except burning waste oil, and plans for water-**** injection.
What about coating the outside of the compressor housing and intake to insulate it from underhood temps?
If you had this done what did it run?
Right now it is is a stock turbo engine with nothing else done except burning waste oil, and plans for water-**** injection.