I finally got to install the filler neck back into the truck. I was wanting to finish up and go home, but I didn't have a real good idea for mounting the filter so I improvised. I don't like it, but it works for now. After I was done, I had a much better idea for mounting the filter so I'll go back and change it later because I don't have what I need to make the mount. This isn't a high dollar, high flowing filter, but I'm only trying to fill the front tank, not run the engine off of this set up. It will be just fine for me. I didn't have the time to wire up the pump, but I wanted to at least try it out. I grabbed a pair of jumper cables and got them hooked to the pump wires. As I was doing this, I was hoping that this is a self priming pump. It sure is. I think it took all of three seconds for the sound of the pump to change when the fuel hit it. It's hard to tell in the picture that I took, but there is fuel flowing into the filler neck from the E pump. Standing back and looking, it's easy to see the bronco tank under the back of the truck. Boy, does it look good!