Just thought I would show off my cool little project I decide to make at work. Billet aluminum injector return line caps, I have 4 made and I have a program ready to go to make the 90 degree caps but have not had time to make any of them yet. I think I have about 5-7 hours into this project so far with programming time and running parts. The run time on 1 cap is about 20 minutes and it is all done in one setup. The hardest part (well not even that hard just time consuming) is DE burring them so I will not tear up the o-ring when I put them on. They snap on to a injector great so they should not leak I know these are nice and round.
I will post up more pictures when I get the 90 degree caps done but that will be a week or better.
Let me know what you think or if you see something that should be changed.
JOHN
I will post up more pictures when I get the 90 degree caps done but that will be a week or better.
Let me know what you think or if you see something that should be changed.
JOHN
You must be registered for see images attach