Well, it's 5:30am............coffee is brewing. I drove 9 hours round trip yesterday to pick the Banks kit up instead of waiting for it to arrive Monday. I grabbed a couple of odds and ends when I was back in Cali as well. I figure since this is the temp motor and the begining of IDI testing I might as well throw as many combos at this as possible and see what she does. I am gonna run the Banks TE06H charger initially, then swap over to my stock
HX35 and then to a modified HX35. All 3 of the spools I am going to run are gated so, I am going to run some hose through the firewall and run a valve that i can control in the cab so I can block the wastegate and see what the differences are. I am also going to install an IAT sensor so I can see how far I can push each turbo until they start pumping hot air. I also grabbed an intercooler so after running all 3 setups without the IC, I will repeat again with the IC.
I am already prejudice in the matter as I belive the modded HX is gonna be the winner. It might spool a little later but it will give a lot more after it's lit. I will try to stick to raw data and not go completely based on butt dyno.
Few more cups of Joe and I'll start twirlin' some iron.
HX35 and then to a modified HX35. All 3 of the spools I am going to run are gated so, I am going to run some hose through the firewall and run a valve that i can control in the cab so I can block the wastegate and see what the differences are. I am also going to install an IAT sensor so I can see how far I can push each turbo until they start pumping hot air. I also grabbed an intercooler so after running all 3 setups without the IC, I will repeat again with the IC.
I am already prejudice in the matter as I belive the modded HX is gonna be the winner. It might spool a little later but it will give a lot more after it's lit. I will try to stick to raw data and not go completely based on butt dyno.
Few more cups of Joe and I'll start twirlin' some iron.