Search results

  1. B

    FS: 6.2 parts and chevy truck parts in SE PA

    I'll see what I can do, I'm having issues with the camera I can use right now. I'm hoping to find my tire depth gauge to get the measurements on them. I'm about 15 minutes from the King of Prussia mall, about 1.5 miles straight off of rt202.
  2. B

    FS: 6.2 parts and chevy truck parts in SE PA

    Most from an '82 Blazer Fenders $125 pair Hood $75 bumpers $20 each Power doors in great shape $400 6.2 diesel heads $100 and $175 6.2 radiator - cI think it could be used on a gas engine, 'its just bigger and has built in tranny and engine oil cooler $150 radiator support $30...
  3. B

    1983 GMC 2500 6.2 4x4 $1200 in SE PA

    sold
  4. B

    1983 GMC 2500 6.2 4x4 $1200 in SE PA

    I do not know at this time, sorry.
  5. B

    1983 GMC 2500 6.2 4x4 $1200 in SE PA

    6.2 diesel turbo 400 automatic NP 208 10 bolt front 14 bolt rear new parts with under 2 years 2000 miles on them(over $2000 in new parts) radiator glow plugs injectors alternator starter water pump belts batteries battery cables shocks dual exhaust...
  6. B

    6.2 pump

    I got one that was on the original engine in my '83 GMC 2500. The P/O scrapped the engine because it smoked very badly but still ran, he took the IP off, so the pump worked when removed about 2 years ago. $100 plus the ride.
  7. B

    1983 GMC 2500 Hi Serria 4x4 diesel in SE PA $2000

    TTT. $1500 OBO without the extra parts, willing to work with you on extras, looking to sell it and get the extra parts out of my brothers place. I bought it originally to get me to my plow truck in the winter, I got a 2000 Jeep Cherokee to replace it and my DD mustang.
  8. B

    1983 GMC 2500 Hi Serria 4x4 diesel in SE PA $2000

    '83 GMC 2500 Hi Sierra 4x4 6.2 Diesel Turbo 400 automatic NP208 transfer case 10 bolt front 14 bolt rear power windows sliding rear window cap dual tanks running boards 2" class 3 hitch PA inspected until december 31, 2009 New parts with only about 2000 miles on...
  9. B

    Broken 6.2 in good truck ?

    If he says it bent a rod, the pan would have had to been dropped to verify this and he could have seen if there was some more damage. I bought a Blazer for parts with a Banks trubo on it. The rod broke into 3 pieces and broke the block in several places. FWIW I sold the complete turbo setup...
  10. B

    Banks turbo

    I just sold a complete banks turbo without exhaust with 2 gauges for $800, I took it out of a blazer that had a broken block.
  11. B

    engine dead,ran with loss of power, then ran good again?

    I only run off of 1 tank as I know the transfer swith is bad. I think it was just out of fuel and had air in the lines when I pulled out of the station
  12. B

    jeep YJ 6.2 conversion

    did this swap start? how's it going? After driving my 6.2 3/4 4x4 I would love to swap the drivetrain(or similiar) into my scrambler or CJ10a. $$$ and time/space will keep that from happening for a long time, but it would be a nice rig if I ever do it.
  13. B

    Dead battery question

    I put another alt. in it and it was putting out enough volts. The original (rebuilt) alt wasn't putting out enough volts. It tested fine at one store and bad at another. Truck has been fine for 2 weeks, went to start it this morning and it wouldn't start. I did some tests and it did not...
  14. B

    engine dead,ran with loss of power, then ran good again?

    I am confused as to what happened. I filled my drivers side tank with 15 gallons(how much does it hold?). I pulled out of the station and truck went 50 feet and lost power. I pulled into a parking lot and it wouldn't start. I turned on the electric fuel pump and cranked the bleeder screw on...
  15. B

    Alternator swap

    My truck has the 7273 alternator in it. Autozone has a 7290 hi-output listed. My truck came with a new one of these on the front seat. Any clue what other engine I could get brackets to fit this (7290) alt to a 6.2?
  16. B

    Alternator swap

    It's been too cold outside for me to investigate hands on, suppose to warm up this week(I don't have a garage:() I may need a new alternator on my truck. Is it a standard GM 10si or 12si or are they diesel specific. I can pull one from a SBC truck at the local yard or am I wasting my time...
  17. B

    Fuel line sizes?

    Does anybody know what size fuel lines (both the feed and return sizes)would be used on an '83 3/4 ton with the 6.2. My feed line is rubber from the tank to the engine...not quite factory stylecookoo I assume diesel lines are larger than gas lines, am I correct?
  18. B

    Dead battery question

    '83 3/4 ton with 6.2 has new batteries, new alt, new starter, all cables are new except for one ground cable. volt meter seemed to be low last night(never noticed if it worked right anyway), slow to crank this morning but it did. Had to jump start it after work, won't start right after i...
  19. B

    Newbie with a few questions.

    What style and size exhausts did 6.2's come with from the factory(did it vary with body style and gvw)? What does white smoke on start up mean(is it bad that my truck has more smoke on one side than the other, it has dual exhaust). Did any 81-87 6.2 trucks/blazers come with factory tachs and...
  20. B

    Turbo 400 bolt size?

    Anybody know what size bolts to use to bolt the flex plate cover back onto a Th400 behind a 6.2? Mine had the cover in the bed when I bought it and I need to put it back on. Thanks for the help?
  21. B

    Changing gauges from export truck

    My '83 GMC 3/4 truck was an export model, the speedo is KM with the MPH in small numbers and the temps gauge is Celsius. Not sure if the oil pressure gauge is metric or not. Can I just swap the guages from a US truck in a junkyard into my truck and have everything work ok?? What is a good...
  22. B

    Newbie with questions

    Looking at some other posts, it seems as though the 6.2 is what it is and forget about peformance upgrades unless I want problems. I was wondering about adding a K&N or the likes. The truck has dual 2" exhaust, if I want to add a pyro gauge I guess I need 2 then. How do you tell if the...
  23. B

    Newbie with questions

    I just got an '83 GMC 3/4 with the 6.2 I don't know much about them....yet. I drove it and it was quciker than I expected, not as quick as my boss's 6.0 powerstoke but it didn't cost me $50,000. Any easy performance upgrades that are cheap? What is the weight of a 6.2? What were the...

Latest posts

Forum statistics

Threads
91,344
Posts
1,130,726
Members
24,143
Latest member
Cv axle

Members online

Total: 249 (members: 8, guests: 241)

Share this page

Top