Hmmm interesting. If I continue to have problems I will seall them. I figured the whole plug had been off. So putting it in should be an improvement I hope.
ok guys. Got my inner fender plastic off and pulled out the idm. Didnt find any water. but the button plug thing that is in the pic was found in the little tabs that it is sitting on. so i can see the circuit board. Looks like mist could get in there. Anyone re seal these up before? also my...
Will be testing into idm shortly. And yes I have tried running the wipers when dry. (Found that idea on here! Love this site) still no issuel. As an experiment I drove through a huge puddle. At least 8 inches deep. At 45mph. And in that moment it did not affect truck at all. It just kinda...
Ok did some digging no luck.
Truck is an early 99 7.3 auto trans.
Every time it rains it will randomly cut out and die for a second but never fully die. It will do it randomly. I thought it was my cps getting interference from the wipers.
How ever yesterday it was sprinkling out. And twice. The...
Thanks for all the help. Im goin to look over the site to see what its like. Pulling a motor of this magnitude. Im sure its real heavy... I may just pull the tigger. Thanks again!
So went looked at truck. Leake appears to be from oil pan seal. . other things. He had the truck pre warmed when i got there(hot raditor). White puff of smoke at start up. No coolant in resevoir.. On the plus side the blow by was not bad at all. Thought i heard the lightest tick at start up but...
Ok thanks! He said its like a 5 inch puddle on the ground. It in the dirt. So was thinkin it might even be a fuel leake and he doesnt realise it. Alsi. What can be done to these turbos?
Hi guys. Been on here before. And had an idi in the past. I am currently looking into a 94 factory turbo truck with 114,000 miles. 7.3l with e40d. The owner says it leakes after shut off. Rear of oil pan by crank. Haven't seen in person yet but any thoughts?? Also was wandering about the turbo...
Thanks for all the helpful replies guys! i was able to make a bit of a road trip and get the 1000w i needed.
and as louck would have a guy came and buaght the truck earlier today.. i will miss the old girl but at least someone will be able to drive an appreciate her now.
Thanks for all the...
Found heater cord melted. its a brand new cord. found a short in block heater element. need to put it on to help the sell. thanks for the help guys. any tips?
i know where it is. it is right above the starter.. i would just like to kniow how to go about removing it.... seeing as it is 0 degrees here i do not want to be finding this out in my drive way...i so far ive found other sites are useless hahah. so help is appreciated. thanks.
p.s i know...
thanks for all the info! but what it was is i backed up straightabout 15 ft then turned right and heard the snap...
but also i noticed if i back and get out and look my tires are on an angle like / \
when the drive straight they are like this i i
sorry for the vauggge descriptions hah
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.