I have a craigslist add here: http://columbus.craigslist.org/cto/5791906383.html?lang=en&cc=us
I would really like to sell the van because I have not been using it since March. It needed a new brake booster and I did not get that replaced until last month. I drove it that wat for months but...
I bought a US Shift (Baumann controls) controller and wiring kit and installed it on my ford van with an e4od transmission. I installed it in late May 2014 and used it for about six months until I scrapped the van and got a new one. It worked great. I planned to install it in the new van but it...
When I change the oil I drain the pan and then use a punch to make a hole in the bottom of the filter. As soon as I broke though the metal I got water droplets. I would estimate a teaspoon maybe less came out then just normal black oil. I didn't see anything when I opened the drain valve on the...
Yesterday I replaced auto lite glow plugs from PO with motorcraft. Two were burned out so lots of smoke when starting.
Before I put the new plugs in the plugs would cycle with clicking sound and gauge jumping after the wait to start light went out. After the new plugs were in the wait to...
Parts are off a 94idi van
IP has 20k on it. Have receipt for $1300 from shop for pump and install last October.
Injectors Have 20k on them. I bought them rebuilt from accurate diesel for $169.
E4od has approximately 80-100k on it. The guy I bought from said it had been replaced 20k ago...
I replaced my 94 van with a 92 van and have been moving some good parts over. Would like to remove IP because I just had it replaced 20k miles ago and keep it for a spare. New van only has 100k on it so it might be a few years till I need it and I don't know the correct way to store a pump...
I am getting ready to convert to electric fuel pump and… I am using a raptor pump which I know is overkill but it has a lifetime warranty and I already own it so thought I might as well use it. On a previous IDI I had been using it without a regulator and all the way turned down it still put out...
I'm replacing my van due to excessive rust. I will be selling it for scrap and thought that I would see if anyone is interested in a good running idi engine or other miscellaneous parts. It has about 260k miles. I am located in Louisville, KY. The axle is a 3.54 that previous owner swapped in.
This is in an E350 IDI N/A ambulance van. Previous owner swapped 4.10 axle for a 3.55. It works well when not towing and it worked ok with a small 2k travel travel but now I've been using it to tow a larger travel trailer i believe around 4k (21ft). It does ok but as soon as I hit any tiny up...
I am looking to replace my current IDI e350 type2 ambulance van. It's a 1994 w/ 250k miles. Runs great (e4od acts up sometime) but the rust level is bad. Pieces fall off every other time I open or close the doors :mad:
I can't decide between two vans (e350 type2 ambulances) I found because...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.