Crack one of the oil supply lines to the head while cranking to see if the HPOP is working. Might check to see if these lines are leaking, and if there is a hole in the side of the HPOP. Check for codes?
My '91 wraps real bad in 1st gear with the 5ver hooked up. Could not use more than 3/4 throttle while loaded with out bad wrap shudder. The '06 does not seem to do it.
Have you called bully dog? Did the dealership update your truck computer. Could be your truck has been flashed but your programmer is set to work with the stock settings. Does the bully dog site ask for the version of your trucks programming? The Ford dealers in Texarkana(near where I am...
Ran into some other front end problems. Found a seized knuckle joint and a seized vacuum hub cartridge. Replaced U joint and steering damper, left hub cartridge out and put it in tool box in the pickup. So now when I put the hubs in I really put he hubs in. The steering box was returned as I am...
Been busy with front end. New question, how much does eliminating the EGR circuit alter the fuel/air mixture. Apparently not much or it would be on the boards somewhere.
EGR was replaced under warranty at 93k now have 103k. Thinking about buying an EGR valve and plugging into it with out installing it. Thus "blocking" the EGR circuit but the computer still operating the new uninstalled(ghost) valve to prevent codes.
Ordered a new steering box today. Flushed the fluid system with 2 gallons of fluid. Things went down hill fast. Instead of pulling left all the time it went to surging left hard or soft slow or fast sometimes pulsing so fast it was like a sever shimmy(death wobble). I could take my hands off the...
Got a letter today from Ford today. Says low tire pressure in the front tires will cause bad shimmy when hitting bumps. This is for newer super duties Anybody else get this letter?
depending on the mix you could be maxed out on weight. By rock do you mean washed 1 inch or do you mean right out of the crusher fines and all? finishing grade gravel is very heavy per cubic yard. Imagine a concrete block the size of your pickup bed, wet finishing gravel would be close.
Howdy, been awhile since I have been here. Bought an '06 6.0 in November. 250 King Ranch 4 door short box 4X4. Clean Oasis except EGR valve at 93k. Currently 104k and seems to be solid. I did have the rear drive shaft balanced, factory weights were 180 off.
My problem is the steering wants to...
k_william is it possible your heater core is partially plugged restricting the amount of hot water? Do you have an after market temp gauge installed? Do you have sufficient air flow through the heater and it is the air temp that is not warm enough?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.