Rear block question.

[mattplumber]

Ive been doing some searching and trying to figure out if f-250's used a 2 or 2.5" rear block factory. Ive seen in some posts where it says 2 and some where it says 2.5. I know the 350's used 4" and since I just did my 60 swap im wanting to level the rear. I was thinking if 250's used 2" and 350's used 4" then I might split the difference with a 3" block. Thoughts?

 

[wmoguy]

I think f250s were 2". I'll swap u my 4" rears for your 2".

 

[mattplumber]

I could probably do that. U bolts too? The only problem is that I cant take my truck apart to send the blocks until I have something to replace them with. My truck is currently my only vehicle.............

 

[Diesel_brad]

F250 are 2.5"
F350 are 4"

 

[itsacrazyasian]

if you wait 2 weeks i'll send you my F350 4wd rear blocks and u bolts (though resuing is a no no....)

 

[wmoguy]

I could probably do that. U bolts too? The only problem is that I cant take my truck apart to send the blocks until I have something to replace them with. My truck is currently my only vehicle.............

I'm in the same boat. Lol.