Search results

  1. I

    Intake Heater Wire relay, where does it go?

    In post number 3 you see two rubber nubs covering electrical wires. The one on the left runs to the Air Intake Heater. The one on the right I am not sure where it runs to. My thought is that it may go to the Glow Plug Control module (first picture in post number 2) as that is where power is.
  2. I

    Intake Heater Wire relay, where does it go?

    The image below is is the intake heater wire on the left side and on the right is the wire I am hoping to find out what it connects to. If anyone can trace this wire back and show me what it connects to that would be fantastic.
  3. I

    Intake Heater Wire relay, where does it go?

    This is the Glow Plug Control Module. You can see that there is a single Hot wire in. Slightly below that wire is another black wire. I am wondering if that is coming from the Intake Heater Relay which is in the next post.
  4. I

    Intake Heater Wire relay, where does it go?

    Hello Everyone, I have a friend helping me with a Duramax project. Issue is we recieved the engine taken apart so its impossible to trace how it was put together. Truck: 2003 CA Duramax The issue: Starting from the intake heater there is a wire going to a relay and from that relay there...
  5. I

    Dual Tanks, Switch and Fuel Gauge

    The tank selector valve is a submissive device to the switch correct? My initial thought was to Diagnose the switch first and valve second. I am hoping the valve is ok and the switch is the issue (wishful thinking). Sending unit could also be the culprit but I would think the fuel gauge...
  6. I

    Dual Tanks, Switch and Fuel Gauge

    Truck: 1992 F250 XLT Ext. Cab Dual tanks I thought I was running low on fuel ~1/4 tank left indicated on the gauge. So I switched from the rear tank to the front tank and the fuel gauge did not change position. I went to the Gas Station, and started to fill the rear tank, and the pump...
  7. I

    Air Seats Option

    I wasn't even looking at the lumbar area, I was concentrated on the sound and the seat bottom. This is so different than anything I have seen. Now I just want to play with it!! Thanks!!
  8. I

    Air Seats Option

    Aha! Interesting. I have never seen this on a vehicle. Usually it is a lever.
  9. I

    Air Seats Option

    1992 F250 XLT The drivers and passenger chairs have a + and a - on a switch located just below the bottom cushion. It does not move the seat (power seat). When you push the + side of the switch there is a hiss like a miniature compressor kicking on. When you hit the - nothing really happens...
  10. I

    RABS or Vacuum Pump or Both?

    Agreed and Done, I replaced the Vacuum pump and the brakes are working as they should but the brake pedal would slowly press down to the floor. Next, went after the RABS unit. Replaced that and bled it. Finally the brakes felt as they should have been. All in all it was a quick set...
  11. I

    RABS or Vacuum Pump or Both?

    Pulled the vacuum line from the booster. There was absolutely no vacuum showing up on the gauge. Dead as a door nail.
  12. I

    RABS or Vacuum Pump or Both?

    Yes, there is AC but it is not connected (electronically, I unplugged it and removed the Belt). I removed the belt as I was concerned about hurting the pump due to a lack of refrigerant. In addition to checking on the vacuum pump I think I need to take a look at the vacuum hose. They look...
  13. I

    RABS or Vacuum Pump or Both?

    Ok, The brakes operate BUT I use almost everything I have to push on the pedal to stop the truck and even then it doesn't stop all that fast or well. It is a super sketchy white knuckle inducing driving. Brake Booster and Master Cylinder were replaced, Brake Calipers were rebuilt and rears...
  14. I

    ATS Turbo kit- complete and working

    THANKS!!! Truck runs and drives its the Stopping part I am now working on!!! I have a new RABS unit to pop on then it is just finding and fixing whatever else pops up. I am still quite interested in the turbo kit shipped to 98059 if it is still up for grabs.
  15. I

    ATS, Sidewinder, Hypermax Turbo Complete Kit

    I am searching for a complete kit. I would prefer a waste gated model but open to any and all kits. I am located in Washington state, local is good but shipping is not out of the question. My Truck: 1992 7.3 IDI 4X4 Auto
  16. I

    ATS Turbo kit- complete and working

    On the compressor wheel photo, there seems to be oil surrounding the edges, is that correct? I am interested in getting this for a 1992 7.3 I just picked up. I need to make sure the motor is healthy prior to adding a turbo but at 174K miles I don't think much can be wrong although it sat for...

Latest posts

Forum statistics

Threads
91,315
Posts
1,130,194
Members
24,121
Latest member
720Diesel

Members online

Total: 829 (members: 9, guests: 820)

Share this page

Top