Search results

  1. IDI-IKE

    Heat

    That actuator only changes from out side air to recirculate. I ziptied mine and my ac is colder and my heat is hotter. That's not your issue either your thermostat is stuck open or your heatercore is clogged up or your hot cold blend door isn't moving
  2. IDI-IKE

    E4od to zf5 swap wiring

    On my 83 chassis with a 84 cab it went like this. The chassis was a factory 6.9 t19 now its a turbo 7.3 zf5 and the cab was originally a F250 460 2wd c6, The manual chassis had a factory jump wire plug where the mpls would connect to bypass the neutral safety switch, The automatic cab had a...
  3. IDI-IKE

    E pump stickie

    it's not quieter than a Holley blue is it?
  4. IDI-IKE

    E pump stickie

    My 84 turbo 7.3 has a facet 40222 mounted to the filter housing bracket with the MG hard line delete kit I like it haven't had any issues with it. My 85 chevy 6.3 turbo has a holley blue it works good too mounted to the frame under the cab but its really noisy. I have a 6.5 diesel factory lift...
  5. IDI-IKE

    Custom 60G glow plugs

    Let me know how it goes. I'll put my electric lift pump in off a 6.5 chevy and report back how that does
  6. IDI-IKE

    What turbo is this?

    I'll be putting ac back in mine but I have the wide short radiator and finding a condenser that fits is next to impossible so I'll be putting a aftermarket one in and make my own lines but I don't see how the turbo will interfere with the compressor mounting at all
  7. IDI-IKE

    What turbo is this?

    I sent it to you LMK if you can open it
  8. IDI-IKE

    6.9 IDI Burning Oil Excessively

    What gears and transmission do you have now? These motors will run against the governor all day long safely but they will burn oil doing it you just need to keep the oil full. My plow truck is a 86 c6 it had a replacement 7.3 put in I forgot the gear ratio but it likes the high revvs and it...
  9. IDI-IKE

    A word about dieselkleen

    adding lubricity to the fuel is adding lubricity so you could really use any oil. I use atf because it's supposed to have quite a bit of detergents in it to keep stuff clean. I've also had good luck with lucas fuel treatment it's pretty thick too
  10. IDI-IKE

    What turbo is this?

    I have what Logfarmer sent me in pdf I tried to upload it and it said the file was too large so I'm not good enough with computers to make it smaller
  11. IDI-IKE

    A word about dieselkleen

    I always dump a quart of atf in each tank that's just what I do
  12. IDI-IKE

    Custom 60G glow plugs

    Yah it's something like that. I replaced the return kit with Russes kit and replaced the olives too. Lift pump looks new as well. I'm just going to put a electric lift pump in next that will prime the system while I glow. After the morning start it pops right off for the rest of the day
  13. IDI-IKE

    Anyone familiar with the VW D24T?

    That's really cool! It has power and cold starts well I don't think the rings are gone its just slow in general like any 80s diesel car nothing like a b230ft. You know a good source for parts like gaskets and timing belts etc? I need to replace that lifter and shim all the valves to spec...
  14. IDI-IKE

    Anyone familiar with the VW D24T?

    I've read they like to blow head gaskets, I also read you can use rabbit 1.6 head studs to help with that but you have to buy 2 sets or talk arp into selling the quantity needed for the 2.4. The odometer is at 315k miles so it can't be too terrible I'm actually impressed lol. It actually ran...
  15. IDI-IKE

    What turbo is this?

    Here's a acceleration video of my truck. It is up a medium incline hill and my speedometer gear is slipping a little bit but its actually pretty quick for a idi.
  16. IDI-IKE

    What turbo is this?

    If you'd do that I would be super happy you can email to me at [email protected]. For the lope I would be bypassing that water separator they are known to cause air intrusion. While its running bump the shreader valve open on the filter housing what comes out air or solid stream of fuel...
  17. IDI-IKE

    Oils, lubricants, filters oh my

    I have access to a nice welder I welded a nut inside the pan. I put my spin on filter behind the bumper I also used a 6.5 gm diesel oil cooler for a second transmission cooler
  18. IDI-IKE

    Custom 60G glow plugs

    I would definitely not run them with out the machining work! The hex will bottom out on the head before the tapered seal at the bottom
  19. IDI-IKE

    Anyone familiar with the VW D24T?

    I picked up a 85 volvo 740 gle turbo diesel and volvo used the VW D24T engine in them which is basically a 1.6 IDI like what's found in the rabbits with 2 more cylinders making it a 2.4 liter straight 6. It has the VE pump that's belt driven off the back of the cam and a garret turbo. It's...
  20. IDI-IKE

    What turbo is this?

    Thats a good idea!
  21. IDI-IKE

    What turbo is this?

    I would absolutely love to see pictures of the turbo paperwork! I'd even be interested in buying that paperwork just to have it in the glove box of my truck I've been restoring! very happy to hear you got her home and running!
  22. IDI-IKE

    What turbo is this?

    Definitely keep this post updated! I would absolutely love to see some paper work on this turbo kit if any. I honestly think it was kinda a DIY kit that was sold that's just my assumption. My kit also came with that canister thing that's inline with the turbo oil feed I just left it out as...
  23. IDI-IKE

    Oils, lubricants, filters oh my

    I welded a bung into my c6 pan and used a a magnetic plug, I bought a universal hydraulic filter housing that takes a spin on filter and put it inline with the cooler lines. I drained my converter aswell and I used john deere hygaurd fluid it shifts very nice. The c6 filter is more of a...
  24. IDI-IKE

    Oils, lubricants, filters oh my

    I run delvac 15w40, all wix filters using a wix powerstroke filter, I use mystic red hitemp grease because that's what we use at work, I use atf and lucas trans fluid stabilizer in my zf5, tcase gets generic atf, front and rear ends get generic 80w90, atf in the power steering pump, I change...
  25. IDI-IKE

    Well....

    Another vote for drw

Latest posts

Forum statistics

Threads
93,001
Posts
1,155,994
Members
26,589
Latest member
tke395

Members online

Total: 848 (members: 4, guests: 844)

Share this page

Top