Search results

  1. rewbrooks50

    No fuel to the injectors.

    I ran out of fuel or the mechanical pump when bad. I changed to an electric pump from my other truck. I had a time getting fuel primed. I should have it running tomorrow.
  2. rewbrooks50

    No fuel to the injectors.

    Reinstall cover CORRECTLY!! - This means the little lever has to hook on the valve inside while you close it, to be able to properly shut off the fuel, or you will have a RUNAWAY when you start the engine. If you are not 100% sure that its correct, have your air cleaner off and a big clean towel...
  3. rewbrooks50

    No fuel to the injectors.

    Think I found my answer.
  4. rewbrooks50

    No fuel to the injectors.

    Reinstall cover CORRECTLY!! - This means the little lever has to hook on the valve inside while you close it, to be able to properly shut off the fuel, or you will have a RUNAWAY when you start the engine. If you are not 100% sure that its correct, have your air cleaner off and a big clean towel...
  5. rewbrooks50

    No fuel to the injectors.

    Finally got the injectors primed. But, when it starts, it's a run away engine. Runs at high RPM and will not shut off with the ignition switch at off. I have to disconnect the electric pump and let run out of fuel. I had the IP cover off. Could I have not installed the cover back correctly?
  6. rewbrooks50

    Injector Lines / Kit for a '93 F-250 7.3 IDI

    I have had these on my F250 IDIT. Fit good and no problems for two years.
  7. rewbrooks50

    IdI cruise control cable/ cab visor

    Do you still need the parts?
  8. rewbrooks50

    No fuel to the injectors.

    The PO replacement IP from Pensacola Diesel. So could be bad. I have a call into Wes.
  9. rewbrooks50

    No fuel to the injectors.

    Thanks, I will check that wire. Yes the shut off does click.
  10. rewbrooks50

    No fuel to the injectors.

    So I need to replace the Complete IP?
  11. rewbrooks50

    No fuel to the injectors.

    Electric fuel pump has pressure to the IP. Are you talking about a shaft inside the IP? I've never had one apart.
  12. rewbrooks50

    No fuel to the injectors.

    No fuel to the injectors. Pulled top cover from IP and no fuel in bowl. Good fuel pressure to the Filter and IP. Have good electrical to the IP Any suggestions?
  13. rewbrooks50

    So what did you do with your truck today?

    Yes the view is much better. I can see my 32ft 5th wheel RV. Had to remove the wing and door glass to weld in the mounting plate. A pain to reinstall the door glass. Cost about $320 for parts and mirrors. I am glad I did it.
  14. rewbrooks50

    So what did you do with your truck today?

    Installed GMC electric tow mirrors. OSB Solutions - CP Addic.
  15. rewbrooks50

    Project Rewbrooks

    I think all of my upgrade parts are salvageable. Thinking of getting another parts truck to swap parts. I still have my 94 Idit F350. I think I need another back up.
  16. rewbrooks50

    Project Rewbrooks

    I'm not any more sore from working.
  17. rewbrooks50

    So what did you do with your truck today?

    Did a little body modifications. Only the truck was injured. I am ok with only a cut and jambed finger. May be sore in the morning. It was my fault, liability insurance only. Need a little while to think what to be. Probably will swap some parts to my stock F350.
  18. rewbrooks50

    Project Rewbrooks

    Did a little body modifications. Only the truck was injured. I am ok with only a cut and jambed finger. May be sore in the morning. It was my fault, liability insurance only. Need a little while to think what to be. Probably will swap some parts to my stock F350.
  19. rewbrooks50

    OSB Dually Bed or Driver side panel

    Damage is in metal panel. The fender need fiberglass crack repair.
  20. rewbrooks50

    OSB Dually Bed or Driver side panel

    Damage is in metal panel. The fender need fiberglass crack repair.
  21. rewbrooks50

    OSB Dually Bed or Driver side panel

    Need the above. I can replace just the driver panel if available. I am in Dallas, Texas.
  22. rewbrooks50

    new here....

    Welcome a board.
  23. rewbrooks50

    Ex Wife- my LONG term build

    Maybe install diyamat or other brand on the fiberglas fenders 7.3L IDIT with a Banks Sidewinder ZF 5-spd manual
  24. rewbrooks50

    cost of E4OD rebuild

    I got a Ford rebuilt for $3,700. 100k/3 yrs at any Ford dealership.
  25. rewbrooks50

    So what did you do with your truck today?

    My truck looks just like yours.

Latest posts

Forum statistics

Threads
92,929
Posts
1,155,105
Members
26,430
Latest member
Brownlee5212

Members online

Total: 787 (members: 1, guests: 786)

Share this page

Top