Recent content by kodiak98400

  1. kodiak98400

    Cracked fuel pump cause

    Looks like its missing the bracket that bolts to the intake manifold.
  2. kodiak98400

    Power door locks

    I used what i had on hand. Silicone spray made by Blaster. If it happens again now i know what to look for. Probably able to get at it with a coat hanger
  3. kodiak98400

    Power door locks

    I think the dog got all the french fries. Should have been a bunch down there.
  4. kodiak98400

    Power door locks

    Update... pulled the seat out, got the door panel out and there's a small rod that attaches to the door latch mechanism when you push in on the outside door knob. It would stick down and not return. Got everything cleaned up a lubricated good and everything works great now. Hoping to find some...
  5. kodiak98400

    Power door locks

    I've been spraying with with everything i can think of with no luck. Going to pull the seat out today and try to pull the door panel out as far as i can to see if i can get my hands in there. I cant remove the door panel completely because there's a screw on the top front that you can only get...
  6. kodiak98400

    Power door locks

    I have sprayed some wd40 down there. Hard to see if it was hitting the linkage or not. Even took it for a drive hoping the vibration would free it up.
  7. kodiak98400

    Power door locks

    I can't unlock my drivers side door. The actuator only lifts the rod about half way up. Key will not unlock door, inside handle does not unlock it either. With the window down i was able to grab the rod with needlenose plyers but cannot lift it and farther. Has anybody had this happen and have...
  8. kodiak98400

    Name the cause of this smokeshow - 6.9IDI+T

    When you installed your moose pump did you unbolt the pump from the drive gear cover or did you remove the drive gear cover from the motor ? If you removed the cover your gears or not timed right. Mine ran surprisingly well for being 180 out. Just hard to start and smoke like crazy.
  9. kodiak98400

    Name the cause of this smokeshow - 6.9IDI+T

    Thats how mine smoked after i rebuilt my motor. 3 to 4 cycles to get it started. Timing was 180 degrees off.
  10. kodiak98400

    Which is correct sleeve for 93 7.3 IDI harmonic damper seal?

    This is the one i used. No machining needed. National 99250 Redi-sleeve
  11. kodiak98400

    ZF5 swap front driveshaft question

    Here's a pic of my cross member. 92 F250 4x4 with a dana 60 swap and the 1 ton driveshaft
  12. kodiak98400

    6.9 heads

    Does anyone have the specs for a 6.9 head. Minimum head thickness , intake and exhaust recession. I'm looking at a set of rebuilt heads on craigslist and i want to make sure they are correct. I have the specs for a 7.3 but not sure if they are the same.
  13. kodiak98400

    Valve covers

    Anybody know why there's a difference in the valve covers ? I though it didn't matter what side they go on.
  14. kodiak98400

    Front timing cover plate question

    here's a home made version of it
  15. kodiak98400

    Timing cover crank seal problems

    I'v had a couple intake bolts off more than once fixing the turbo oil return leak at the valley pan.
See more

Latest posts

Forum statistics

Threads
91,284
Posts
1,129,785
Members
24,099
Latest member
IDIBronco86

Members online

Total: 621 (members: 2, guests: 619)

Share this page

Top