Recent content by DaveBen

  1. DaveBen

    Possibly cavitated engine?

    It will look milky if oil and water are mixed together.
  2. DaveBen

    Changing Transmission Fluid.....

    I have used Motorcraft filters and oil in my past trucks. I no longer own a truck.
  3. DaveBen

    85 6.9 IDI Will not run

    I would suspect several others have made the same assumption about the feed pump not doing its job. I think there are a couple of reasons for thinking this; You cannot see the results of the feed-pump-to-the-injection- pump. If you have the pressure at the feed-pump, then it is doing its job...
  4. DaveBen

    Dead 7.3 IDI Diagnosis

    The posts getting warm/hot is from resistance at the post connections. Clean then real good! It is the little stuff like this that causes or contributes to bad starts!
  5. DaveBen

    Dead 7.3 IDI Diagnosis

    Also check the other end of each cable. They can be corroded there.
  6. DaveBen

    Grease for driveshaft slip yoke splines?

    My 1992 F-350 was not Keyed and I put it together out of phase and it SHOOKED until I got it phased.
  7. DaveBen

    Grease for driveshaft slip yoke splines?

    Please mark the position of the slip joint so you can put it back the same way it came out. If you get the driveshaft out of phase it will shake.
  8. DaveBen

    Typ4 logger cam shaft

    Russ is no longer with us. I believe his business is being run by family members.
  9. DaveBen

    Dt466E trouble

    Is it spinning slowly?? You need to have good batteries to enable it to spin at 500 rpms. Bad batteries are the No. 1 problem with No Start!!
  10. DaveBen

    help water in fuel light

    Hi Brad! Please fill out your signature by going to your image at the top left corner of this page. Click on Signature and fill out your information. This will stop everyone asking "What truck and year to you have?". Makes life better! Dave
  11. DaveBen

    Cup holders

    Cupholder Season is back!
  12. DaveBen

    Recycle oil

    Do a search for WMO on this site. Many posts for Waste Motor Oil.
  13. DaveBen

    Volt regulator

    If the engine is running, I would say "yes". If it is not running, you have to replace the batteries.
  14. DaveBen

    3g alternator conversion--pulley problem.

    Loctite, along, will do the job of securing the nut. This is what Locktite is for. They make two kinds; perminate and removable.
  15. DaveBen

    Coolant to engine locations

    Your water leak could be from one of the freeze plugs, on each side. They can get corroded and leak.
See more

Latest posts

Forum statistics

Threads
93,001
Posts
1,155,994
Members
26,589
Latest member
tke395

Members online

Total: 825 (members: 2, guests: 823)

Share this page

Top