Recent content by 737INSP

  1. 7

    front shock problem

    Thanx for the help guy's.....i'll get right on it!!!!;Sweet
  2. 7

    front shock problem

    I just installed 2" spacer lift to the front end and larger tires. The other day I hit a pot hole on the highway and the truck started hammering on the left side wheel. I damn near shook me out of the cab! Could this mean stock shocks are now to short to recover?? What lenght shocks and brand...
  3. 7

    Turbo Damage

    No, I just put on the new intake...They have only seen the new exhaust...I'll make an appointment this week as soon as I get it back to stock...and see where I stand...
  4. 7

    Turbo Damage

    Sorrry for the late reply! When I took the intake tube off I noticed that the edges of primary blades were damaged. By primary I mean the first set of blades, there are smaller blades behind them. I do believe it was my mass air flow sensor screw because it is now missing. how it got there is I...
  5. 7

    Turbo Damage

    Hey guy's! I was removing the baffles from my intake near the turbo inlet, and my jaw dropped when I saw the turbine wheel blades! They all had equal amount of damage to them, looks like they scrapped the concrete floor. It's F.O.D. I'm sure! Does anyone have a part number or price for the...
  6. 7

    Silencer ring removal

    Sorry for the late response! Yes it was the lower boot connecting to the turbo flange! I found it recently when I was doing the cold air BHAF install. Thanx guy's for all your help!! ;Sweet
  7. 7

    Silencer ring removal

    Hey Bros... I read an article about removing the silencer ring on my 2004 600 turbo to get better sound out of that thing and so I did. I was told it would'nt effect performance and that this was something dodge ordered from cummings to keep the whistle down. So I went ahead and removed the snap...
  8. 7

    Check engine light on

    yes, did re-connect maf sensor and light did go out after a few starts. A buddy at work let me use his MACK diagnostic. And will remove code this weekend! thanx for all the advice!....
  9. 7

    Check engine light on

    Just removed my airbox in preperation for a cold air intake filter install. I disconnected the mass air flow senor to remove box and re-installed. I now have a engine light on the dash...should I remove battery cables to remove this fault? thanx for any help! :confused:
  10. 7

    Which cold air intake

    Thanx for all the reply's, i'll check those out!.... ;Sweet
  11. 7

    Which cold air intake

    Hello all, I'm considering purchasing a cold air intake for my "600". Which one should I consider? AFE? AIRAID? ect......thanx for any assistance!
  12. 7

    New exhaust question

    I've just installed a new exhaust on my "04" 600. It run's from the turbo back which removed the cat coverter. Should I have the truck computer analyzed (airflow) ? seems to be running great so far. thanx
  13. 7

    05' ...

    Sorry to burst your bubble but i've seen that tail decal on two truck's here in ohio.
  14. 7

    2004 H.O. 2" lift

    Hello everyone! I have a 2004 2500 H.O. and I'm looking for a good 2" lift kit. Does anyone have any info. :thanks:
See more

Latest posts

Forum statistics

Threads
91,324
Posts
1,130,348
Members
24,130
Latest member
JFMac

Members online

Total: 520 (members: 7, guests: 513)

Share this page

Top