scsmith42
Latest activity Postings About
-
-
scsmith42 reacted to Clb's post in the thread Here is Practical Explanation about Next Life, Purpose of Human Life, philosophical/religious facts, theories etc. with
Like.
Reported -
scsmith42 replied to the thread What is this vertical bar tow hitch?.Easy place to attach a strap to pull something out. I have one for my CJ5.
-
scsmith42 replied to the thread Possibly cavitated engine?.Sounds like a cracked cylinder at the bottom of #4.
-
scsmith42 reacted to Olds64's post in the thread Throttle Cable Receiver Connection keeps "Popping Off" of the Injection Pump Arm with Like.
You could check Summit Racing and Jegs for cable ends and ball studs. Maybe you could remove the OE ball from the throttle arm and...
-
scsmith42 replied to the thread Throttle Cable Receiver Connection keeps "Popping Off" of the Injection Pump Arm.Sounds like an alignment issue with your cruise control linkage to me. Can you manipulate the brackets so that the cable has a...
-
Ive got plenty...... but i do like to look at em....and since ive been on this forum ive often wondered about Mr Bronco's bronco that...
-
Yes and no. The Duralifts aren't worth the cardboard that's used in the box these days. Older ones were good. New ones aren't. Now for...
-
scsmith42 replied to the thread Wild Dreams!.Get in line! LOL
-
I sure would like to own that bronco…
-
Ahem.....lol......uhhhh..... well...... i just HAD to bump this....... sure its 12yrs old.....SURE No one ever responded to it...
-
scsmith42 reacted to franklin2's post in the thread Grease for driveshaft slip yoke splines? with Like.
Be careful saying that. For example you have wheel bearing grease which is much thicker than chassis grease. We were also where I work...
-
scsmith42 replied to the thread Source for quality rotors?.I have no complaints for the new rotors that I sourced from Carquest for my 1990 F250.
-
Diesel with a manual trans and turbo... $1200 wouldnt bother me at all. Even at $1500
-
Not sure about the blocks, but as long as your u joint angles are greater than half a degree and less than 3 degrees you'll be fine...
-
scsmith42 replied to the thread 2000 mile trip in 1990 F250 with 2,400 lbs in bed?.That was some good insight about the Timbrens, I’ll keep that for future reference. The F250 does not have any overload Springs on it...
-
-
Loading…
-
Loading…
