mankypro
Learning Slowly...
The plastic intake that shipped with my used ATS kit has a number of quarter size holes drilled out the bottom of the plastic flattened part. The is not OEM, although it was done very cleanly. I can only assume that this was an attempt by the previous owner to increase the airflow.
Since this mod allows the intake to suck warm air from the engine compartment I'd like to replace this portion of the intake scoop so that I'm grabbing air from the grille or below it or whatever.
Are there any after market pre-packaged solutions for intakes? Anything anyone would suggest? I guess I could have an aluminium pipe and scoop custom made to replace it but that sounds costly. Any ideas?
Since this mod allows the intake to suck warm air from the engine compartment I'd like to replace this portion of the intake scoop so that I'm grabbing air from the grille or below it or whatever.
Are there any after market pre-packaged solutions for intakes? Anything anyone would suggest? I guess I could have an aluminium pipe and scoop custom made to replace it but that sounds costly. Any ideas?