jim x 3
1988 F-350 DRW
My truck has a brake controller installed by (I presume) the PO. Its a black brick mounted in a bracket below the dash and above the accelerator. TEKONSHA is lettered on the side but there is no model info. It has a slide switch on the end and a single red LED that goes on when the brake pedal is pressed. There is a 6 pin trailer connector on the rear bumper that has been damaged beyond repair.
I'd like to confirm correct wiring from +12V power to the controller and then on to a (replaced) trailer connector.
I have sent 2 emails to Tekonsha asking them how to determine the model # of my controller and get owner/installer info for it. They have ignored me.
Does anyone on the forum have any info?
Thanks,
I'd like to confirm correct wiring from +12V power to the controller and then on to a (replaced) trailer connector.
I have sent 2 emails to Tekonsha asking them how to determine the model # of my controller and get owner/installer info for it. They have ignored me.
Does anyone on the forum have any info?
Thanks,
Last edited: