notenuftime
Full Access Member
I was told when I went from dmf to SMF it would be a bit more noisey but I'm getting some grinding noise and it doesn't sound right to me. Is this just SMF noise or is something going wrong.
That doesn't just point at SMF over DMF.
DMF are mostly junk. I could count on one hand the people that like them.
Is this first run after SMF install?
Do you have the flywheel dust cover installed? Many have had to modify it.
Sent from my SAMSUNG-SM-G935A using Tapatalk
I'll have to look, I just remember nothing being in the way when I put it all back together. I'll have to remove that pipe tho to take my cover off.It could.
I seem to recall that being a theme when doing the swap.
Easy to remove it to see if the sound goes away.
Sent from my SAMSUNG-SM-G935A using Tapatalk
Same with mine, goes away with throttle. I guess I'm use to noises like these being very bad. InMy single mass make a bit of noise, I guess you could describe it as a grinding noise in a way but more like a loud vibrating noise. Goes away when on the throttle and decelerating but when cruising with light load on it it gets kinda louder?