Parting out 2 trucks

[cbarm]

The Sterling 10.25 w/ 4.10, is it from a dually pickup by chance??

 

[freebird01]

No...at this point i only have a srw sterling...not sure whats going to happen with my other truck yet

 

[96_Bear]

Was by chance either one of these an automatic? I need thetcase range selector that you depress to go from 4H to 4L.

 

[freebird01]

nope...both manual trans trucks

 

[sandrow]

got a tranny?

 

[vanet]

I would love to have your axles, but alas, just too far. If you get to parting them out, I would like the sterling 3.55 gears and the d50 3.55 gears. Thanks

 

[freebird01]

im keeping the transmissions

 

[lindstromjd]

I don't suppose you have a 4wd steering gear box left, do you? I'm trying not to throw my hammer at my truck, because I can't get the power steering to work.

 

[The Warden]

I don't suppose you have a 4wd steering gear box left, do you? I'm trying not to throw my hammer at my truck, because I can't get the power steering to work.

FWIW the gearboxes are the same between 2 wheel drive and 4x4. For that matter, the steering gearbox that's in my truck was originally purchased for an '84 E-350 van

 

[chvycmnslvr68]

yea all i have is D50's id rather sell the axles whole.

Are these the solid front axles .... if so I might be interested in 1 I may be able to have a friend pick it up if you could meet them with it to load into a ****** trailer .. and how much would one be .. ( 3.55's)

 

[freebird01]

No.. a d50 is a ttb

 

[chvycmnslvr68]

I might still be interested in one of the front axles if the price is right ... I would be puttting it into an 86 chevy CC dually just like my avitar ... but it is not currently 4X4 .. it is my brothers truck and we have a '90 cummins and a '94 NV4500 4X4 tranny setup to put into the truck ... we are looking around for a front 4X4 front axle with the left hand front driveline to work with the nv4500 tranny/t-case we already have ...I have also considered going with the IFS 4X4 front suspension from an '88 or newer 1 ton chevy ... I can fabricate pretty much anything that I set my mind to ..

 

[freebird01]

the one has already been scrapped and the other is still on the ext cab frame. I have a deal pending on the frame and axles on that truck so at this point i dont have any more available

 

[goatwrangler]

To wake up an old thread...how much for the front drive shaft slip yoke shipped to 46075? Thx

 

[alienturtle]

looks like my one parts truck has 3.55 gears so that meas i have (2) D50 3.55 fronts and a sterling full float 3.55 rear also

Would u be willing to sell just the 355 ring and pinion from the 10.25 rear?

I didn't read half this thread so sorry if it's already gone