D60 driveshaft?

[NJGearhead666]

Ok tonight i picked up a D60 out of a 95 F350 with springs and everything. Now some people including the guy i bought the D60 from says i can use my 250 driveshaft. some don't. What is the difference between the 250 and 350 driveshaft?

 

[mobilemech]

the f350 driveline has a cardigan or CV joint on one end. the f250 shaft will work if you have a d50 TTB in the truck you are swapping the D60 into

 

[towcat]

you are going to need alot more than that. you are missing the D60 front driveshaft, the yoke specific for the D60 driveshaft and the crossmember.
check out these two threads......
http://www.oilburners.net/forums/showthread.php?55946-pitching-driveline-angles

http://www.oilburners.net/forums/sh...es-between-D44-50-and-D60-transfer-case-yokes

 

[junk]

When I did my dana 60 conversion I used an F250 driveshaft with normal U-joints. Never noticed any problems with it. I also went from 2x4 so I ended up making a crossmember and stuff.

 

[kodiak98400]

I used my stock driveshaft off my TTB 50 when I did my D60 swap.

 

[subway]

i hope you got the panhard bar and brackets, they can be hard to locate. Jason, freebird was working on replacements

 

[NJGearhead666]

Yup I got the panhard bar and the brackets. I have a Dana 50 ttb in the truck now.

 

[Agnem]

Take lots of pics and make it into a write-up. It would be a nice add to our technical library.

 

[NJGearhead666]

Already started checking it out and making my parts list. Just got done sandblasting the panhard bar and bar bracket