forcefed
Full Access Member
Well I finally got my tank mounted in my bed and fuel lines hooked up. I thought I would try to start bleeding the air out of my lines on the motor. So I switched on the electric pump and started bleeding the air out of the filter housing and moved on to the injector lines. Well here is my problem. I got fuel to the IP but cannot get any fuel out of the IP or lines by the injectors? I've tried cranking it over and over, I loosened all the injector lines and can not get fuel out of any of them. Is my IP gelled up inside somewhere? I even took the fuel filter off and put a new one on and filled it up with power service. I have fuel coming back through the return line to the tank. (a steady flow too) Can I take a heat gun and heat the IP up? Its about 20 degrees today and was in the single digits last few nights. It has sat for about a month. Any ideas would be greatly appreciated