Late_99_psd
Full Access Member
Hey yall, we put a new master and slave cylinder on the IDI project (91 7,3 IDI if you don't know) and its being a PITA! (of course) We bench bled the system out of the truck and it had no bubbles and felt good and firm, so we put it on the truck and then, boom, air bubbles galore! So we beld it out on the truck and its ok but the clutch dosent engage untill about 2" off the floor.
Do ya'll think that we need to bleed it more and what tips do yall have?
Do ya'll think that we need to bleed it more and what tips do yall have?