I picked up a new master cyl for the clutch and it's different than the one I pulled off. My old one is straight up and down and the new one has the reservoir leaning off at an angle. Is there any problem with using this one on here? It looks like it would be easier to install . At least you can get a socket on both nuts on this setup.
angled clutch master
- Thread starter RLDSL
- Start date
bad news....
it's the wrong one.
87-91 used the offset bolt pattern
92-97 used the straight bolt pattern one.
it's the wrong one.
87-91 used the offset bolt pattern
92-97 used the straight bolt pattern one.
Dang it. This part number is the same one Advance lists for 92-97, they do list a different one for the earlier , I'll bet they got it backwards.
some of them will turn in the mount plate
DowneyB
Professional
Hmmm. There are holes in my firewall that allow me put either one in there. Of course, the intelligent me ran wires through some of them, so without a lot of redoing, I'm limited to the angled ones. The MC I have has had no problems sitting at a 20 degree angle, though. I'll report back if it ever does
EMD_DRIVER
Say what?!?!
Mine was angled when I got it... Just turn it in the mounting plate and all is good!
Just have one cold beverage ready if I ever come thru Arkansas.
