Knuckledragger
blowing chunks and grabbing porcelain
Are the pinions cut with different length splines, or do only the yokes have longer splines? Trying to find out if I need to only replace a yoke or the gearset as well. Thanks!
Physically it is possible however it will not be good for the axle. The yolk isn't long enough to keep preload on the bearing and will eventually cause the pinion to fall into the pumpkin damaging everything in the internals. This is why I had to rebuild the 10.25 in my jeepYou can put a short spline yoke on a long spline pinion. That’s how it’s set up in my truck after I regeared. I also used a ratech crush sleeve eliminator
Sent from my iPhone using Tapatalk