Search results
-
Crew cab door window seals
Does anybody know where I can get a set of window seals for my 86 f350 crew cab. Everything I see online is for a regular cab. Sent from my SM-G530T using Tapatalk- mackmack
- Thread
- Replies: 3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Crew cab door window seals
Does anybody know where I can get a set of window seals for my 86 f350 crew cab I have looked on line but can't find anything for a crew cab. Everything I have seen is for a regular cab. Sent from my SM-G530T using Tapatalk- mackmack
- Thread
- Replies: 2
- Forum: 6.9L IH & 7.3L IDI Diesels
-
7.3idi parts
I have some 7.3 engine parts. Engine had about 260xxx on it . I lost bearings on the bottom end witch is why I am parting it. I believe the block is a reman . I have a set of heads and pretty much everything else that goes with it. Will get some pictures of that stuff posted soon. Is there any...- mackmack
- Thread
- Replies: 2
- Forum: Marketplace
-
Bobcat 743 skidsteer
Does anyone here have a experience with these. It has a little 4cyl na engine made by kubota. I recently purchased it . It has a few issues. No one being that it overheats. It starts and runs but it over pressure the coolant system causing it to blow our the cap on the coolant reservoir. Rad...- mackmack
- Thread
- Replies: 4
- Forum: General Diesels
-
50 gallon diesel auxiliary fuel tank
I'm selling my auxiliary fuel tank as I don't really need it. I believe it's a 50gal tank. It's made by snyder tank co. Asking 150 obo. Local pick up only I can't ship this thing. Thanks Sent from my SM-G530T using Tapatalk- mackmack
- Thread
- Replies: 1
- Forum: Marketplace
-
Why does this block not seem to have a serial number
I have a 7.3 out of a 88 f super duty. I pulled this engine out out of my truck and few months back. I have been slowly pulling it apart . The engine is shot i lost bearings on the bottom end but today I noticed something I never looked at before. Next to to the injector pump in the block...- mackmack
- Thread
- Replies: 10
- Forum: 6.9L IH & 7.3L IDI Diesels
-
6.9 loss of power stalls then dies
I have a 86 f350 with 6.9 ats turbo and four speed. Wile driving it will lose power . If I feather the throttle I can kinda keep it running for a short time but it will stall and die.after this you have to really crank it to get going again. Both my fuel tanks are full. Fuel filters and lift...- mackmack
- Thread
- Replies: 23
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Possible air in fuel lines
Recently swapped a 6.9 into my 88 f super duty. The 7.3 died on me. Bought this 6.9 off a friend of mine I test drove the truck it was in so I know it is a good running engine. I finally got everything together yesterday and was ready to fire her up. I cycled the glow plugs and cranked her...- mackmack
- Thread
- Replies: 15
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Motorcraft parts
Does any know where I can find a rear Main seal(motor craft) and a oil cooler reseal and gasket kit .I am really sealing a 6.9 for my dump truck .I have tried rockauto napa and auto zone no luck on motor craft stuff. Where do you guys go. Thanks for your help. Here is some pics for the he'll...- mackmack
- Thread
- Replies: 26
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Hello oil burners new here
Hi all I'm kinda new here been lurking around for some time. Just pick up my second idi this is a 6.9 turbo with gear vendor overdrive. I was hoping someone here could give me some info on this turbo set up . It's a garrett turbo. I try to attach some pics. thanks for your help. Sent from my...- mackmack
- Thread
- Replies: 12
- Forum: Introduction
-
Wtb zf5 flywheel inspection cover
I'm looking for a flywheel inspection cover for my 88 super duty . Please pm if you have one you are willing to part with.thanks. Sent from my SM-G530T using Tapatalk- mackmack
- Thread
- Replies: 0
- Forum: Marketplace
