Recent content by bj58
-
99 f250 no trailer lights, checked all fuses and relays.
I think I found the problem, it's the 7 pin connector. Now that I've calmed down I went out and retested the factory trailer harness. And it has power. So I'm going to replace the 7 pin connector Thanks.- bj58
- Post #3
- Forum: 7.3L Powerstroke Diesels
-
99 f250 no trailer lights, checked all fuses and relays.
It's not the trailer, I connected it to another vehicle. It's not the 7 pin connector, i removed it and tested from the factory harness under the bed. I have removed all fuses and relays and tested, that includes under the hood, under steering column and under the radio, all tested fine...- bj58
- Thread
- Replies: 5
- Forum: 7.3L Powerstroke Diesels
-
-
Brake problem
The other day my rear driver side brake locked up, by the time I pulled over it was smoking a little bit. I had to hit the brakes hard to keep from nailing a car. I replaced the piston(the thing that pushes the pads out) not sure of the proper name. I thought this fixed the problem but not so...- bj58
- Thread
- Replies: 5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
Well guys I got it going I guess it just had to turn over about 40 times. All the sudden fuel started coming out of the injector lines. I reconnected them and she fired right up Thanks again for all the help- bj58
- Post #17
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
I read over this before the install http://oilburners.net/brian/idi/FuelInjectionServicing.htm If I do not have fuel going to the injectors why would there be fuel at the return line? I have the fuel line removed from all 8 of the injectors so I can see if/when the fuel gets there. Is this...- bj58
- Post #14
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
Not sure about the return line I guess to test just remove the line and c if fuel comes out?- bj58
- Post #7
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
It was a rebuilt pump I have not removed any covers from the pump The wire was to verify the switch is working- bj58
- Post #6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
The fuel has not made it to the injectors yet Do I just keep cranking?- bj58
- Post #3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
replaced injector pump and unable to get the truck running now
I replaced my injector pump yesterday, and can not get fuel out of it. here are my steps thus far. I removed the fuel line into the pump and turned the truck over. It's dumping fuel to the pump. I have the fuel lines to the injectors removed and have turned the truck over about 20 times...- bj58
- Thread
- Replies: 18
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Biodiesel WVO anyone running in there IDI
Yes but the question was IDI trucks running biodiesel Splitting hair ;)- bj58
- Post #17
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Biodiesel WVO anyone running in there IDI
Smolkin letting it settle for two weeks does that do the same as washing? I would like to come and see your setup Pm sent- bj58
- Post #15
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Biodiesel WVO anyone running in there IDI
I know I want to convert the WVO into Bio and run just Bio. because my truck is not a daily drive I plan on keeping the processor small 30G max. although if the savings is worth the time It might became a daily drive ;) I plan on washing the Bio after processing then drying. I had an...- bj58
- Post #13
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Biodiesel WVO anyone running in there IDI
Here in the south the temp is not to bad. We might get 2 or 3 days a year in the teens, most of the time it's in the upper 30's lower 40's. Hell this year I think christmas was in the upper 60's I might be wrong. but U get my point. I've ran the heater in AM and the AC in the PM. (Thats...- bj58
- Post #9
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Biodiesel WVO anyone running in there IDI
Devon, do you process the WVO or just run it as is. I plan on processing it into biodiesel. Do I need to purge the bio from the system before I turn the truck off?- bj58
- Post #3
- Forum: 6.9L IH & 7.3L IDI Diesels
