Does anyone know of any diesel mechanics or shops in the Bay Area that can do an engine swap?
I don't have the space or overhead lift to do it and will have to pay to have it done.
I'm planning on getting a used engine from a wrecking yard to replace my tired 6.9 in my 86 f350.
I'm in the...
Thats kinda my thinking. I'm gonna put a clamp on amp meter on the pos.to starter and see how may amps it draws.
I read somewhere that it should not exceed 500 amps.
Anybody have any input?
Thanks
Update
2 new Interstate batteries and it still cranks slow. Sounds like a small block chevy with the timing advanced a little. Not as fast as it was doing last week.:confused:
I loosened the 2 most forward injector lines and a little fuel looked like it dribbled out after cranking.
Bought a new...
I ordered "constsant duty" glow plugs and installed them about 4 years ago.
Haven't had one starting problem from glow plugs since. At $30.00 a pop, they're expensive but never have to worry about them.
I changed the filter and was trying to bleed it when the batteries went flat.
After the jumps, I was getting fuel out the bleeder.
This is the first time in 7 years the old girl let me down.:mad:
I'm home now, had to get towed. Gonna charge up the batts and see if I can't figure it out.
Thanks...
OK, heres a new one for me.
Lately, the old truck started to turn over a little slower than usual.
I need to change the return lines. If I park with the nose pointed uphill, it gets air in the lines and takes a while to start.
Earlier in the week I had to park uphill in my driveway for a couple...
Alcoa only lists 87 and up. I called to see if they would fit my 86 4x4 dually and they didn't have a clue.
Is there any difference between an 86 and a 87 as far as wheel fitment?
Yeah, thats what I was thinking. Just wanted to make sure there wasn't some hidden freeze plug under there.
It could very well be the gasket as the bearing feels tight.
Thanks for the replies. Always good to get some other opinions before surgery!LOL
Oilburners always delivers!
Howdy,
I need some diagnostic help please.
I replaced my waterpump about 4 years ago.Lately,I've seen coolant dripping from under the waterpump.
Today I topped off the radiater with water and water was flowing
pretty fast from below the WP. I gave the fan a tug,bearings seem tight. Is there...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.