I have a set of rubber bushings laying around and that's what I plan to use I want too say they are moog bushings and I figure a hammer would be plent to beat that ring in I have installed a lot of things you "need a press for" with a hammer and the right sized socket or piece of pipe or...
Honestly I was just gonna take the whole thing out with an air chisel so do ya think all I'd need to do is pull the bolt down and pry down the I beam? I do not have anything but a torch and air chisel
Has anyone replaced their I beam bushing on a 4 wheel drive TTB? I was just wondering if you have too pull axle shafts and drop the I beam off the leaf spring? Any input would be helpful I would like to have some clue of what is required to do this job thanks a lot in advanced!
Have 2 glow plugs I cannot get out of the head and I'm sure it's low on compression. also i think it burns more oil than fuel. time for a new engine that one was free and served its purpose for a year lol
It is a cross between an 86 f250 and an 86 f150. The electrical system is kind of crap but it sat 4 months and it was about 14 when i started it. Took me about 10 minutes to start it and it purrs like a kitten. The story is the guy put 3500 in it about 10 years ago and just used it around the...
I have seen nothing but good out of my bfg all terrains. I have a set of 295/75/16's on my truck i got used for 175 bucks they didn't have a whole lot of tread on em. I've put around 8,000 miles and can barely tell I've drove on em since I got em. They do damn good in the mud and plow through...
This ole girl sat in a barn for 20 years with a blown head gasket. The guy sold it to me with 105,*** original miles and gave me an extra engine for 250 bucks. I spent about 600 in bearings and brakes and tires and she was running on the road like a dream. The engine I put in was just a free...
I figure i was a little less then 7,000 pounds pulling in the 8,000 pound class. I pulled just under 175 feet. I thought it did ok the engines a little wore out and i wasn't too the floor either. I was suprised at first I didn't think it was going to pull it with the tires i got on it.
This is not technically my daily driver because i have my other truck. Since may this year i've pu almost 5000 miles on it though and she is still running strong. I pulled in 2nd gear low range and didn't have my foot too the floor, so I think if i did it again I may get a little further...
She pulled pretty decent for an old wore out 6.9. Anyone else ever pulled a stock 6.9? what kind of distance did you get if you did? Just curious too see what everyone thinks. You may have too copy and paste the link in your browser if you want too watch...
I just picked up some new rims cheap that need new tires bad. I like the Mastercraft Courser mt's but I cannot find a place that sells 33/12.5/16.5 Anyone know where too find them or even if they are still made?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.