-
-
Cubey replied to the thread My '89 is dead, what's happened?.If the rod thing is broken, the ignition switch will feel floppy/loose in rotation. It could also be your starter relay/solenoid. If... -
Even better to fuse each individual circuit after they leave the buss bar. That's also how they do it from the factory so the maximum...
-
Cubey replied to the thread 12V power for accessories.Yes [battery]-[relay/solenoid]-[fuse panel]-[accessories] And the relay/solenoid activated from radio switched power source. Although...
-
Okay so just to clarify from everyone’s ideas and info, I run a fuze box from my battery, to the accessories with the continuous relay...
-
Cubey replied to the thread 3G alternator upgrade.You might try loosening the curved bar that the alternator tightens to and rotate it more to the passenger side. I'm running stock...
-
-
I don’t even remember when I acquired this, but apparently I had a complete kit ready to go to upgrade the alternator to a 3G. Even had...
-
Yeah I knew that, but I didn’t know about overloading the FSS wire with multiple extra circuits attached to it. If I remember correctly...
-
Cubey replied to the thread 12V power for accessories.Yeah, that's just the first example I saw.
-
The particular relay that Cubey linked says that it's rated for 85 amps in the description. I don't know what you're planning to power...
-
Cubey replied to the thread EGT questions.That's the brand the RV had from way back around 1985-87 with the 085 kit, and it still worked. As opposed to the Banks branded one...
-
Ordered an isspro egt gauge. Still waiting to hear from Justin about the down pipe. So close to having this project done I can almost...
-
Cubey replied to the thread 12V power for accessories.Yes. That type of solenoid is typically used as a battery isolator, such as on old RVs, but your intended use works too. Put a fuse...
-
Cubey replied to the thread 12V power for accessories.A continuous duty solenoid like this that activates when you turn the key. Ignore the down for maintenance error it's showing here, the...
-
Cubey posted the thread Extension fitting needed for e4od test port temp sender? in 6.9L IH & 7.3L IDI Diesels.I've been putting off installation of the temp gauge that I pulled from the RV that was on the hot line, installed in a tee that came...
-
-
I did some experimenting on my way home. Every day I drive up a hill that has about a 6.5 average gradient for almost 3 miles. In 4th I...
-
-
Loading…
-
Loading…
