Latest activity
-
The plastic mightyvac I had didnt last long. Mac tools offered a solid aluminum one that not only had vacuum, but a reversing dial to do... -
I've had pretty good luck with my Harbor Freight bleeder. I thought it went bad because it quit pulling out the old brake fluid...
-
I've had good luck with our units. They're usually good for a few years, and are only tossed because of damage(stupid users), not...
-
I've got a few vacuum bleeders/fluid extractors. Brake fluid is cleaned up easily enough by soap and hot water, then I let it air dry...
-
SThis is what I am talking about; Go out and start your truck out in 1st gear and wind it up to around 2500 rpm, and then quickly drop...
-
Ssieg01 replied to the thread Best radiator hose clamp?.I like these clamps because they do their job equal and you can tighten them more. Extra nut may not be necessary. But since the bolt is...
-
SThats good information. When I rent out my timing meters I suggest timing these engines to several differnt degrees of advance. Its...
-
Ssieg01 replied to the thread Powerstroke 2 IDI no Turbo conversion.My idea is to rescue the broken IDI engine. I have no intention to go with HEUI. I want to stay mechanical. My problem is just, that it...
-
OOld Goat replied to the thread Best radiator hose clamp?.My 82 Datsun 720 KC had the OM 300ZX clamps when I bought it new. Never had a leak problem with them. Goat
-
Pesky worm gear clamp on the lower radiator hose at the radiator kept working loose. I happened to be at Harbor Freight and saw these... -
OOld Goat replied to the thread Rear main seal replacement.Hacked89 did have a good YT Video of installing the Real Main. Guess he took it down. I watched it several times before I installed the...
-
OThis is why I like to use a thin coat of RTV on both sides of most gaskets. It makes clean up SOOO easy the next time. The old gasket...
-
been wanting a e locker for several years now, And finally got around to it! made a short video about it as well -
-
david85 replied to the thread e locker 10.25.Nice job! As I mentioned on the other thread, the factory bulkhead connector is probably not worth the trouble. Using a heat shrink on...
