razorback
Full Access Member
the gcodes from the 7.3 turbo will fit on the 6.9? i have a banks turbo and am thinking i need a new ip so while i was at it thought i would just get the turbo one. any pros or cons about going this route?
g code injectors and ip on 6.9..
- Thread starter razorback
- Start date
dyoung14
Is getting worn out
yea they will work on it the pump is supose to be a better pump than a 6.9 pump, but i have herd that g code injectors ain real good, i think most people prefer bb or something like that
Again, my supplier says all that is available now are ee codes set to turbo pop pressure or na pressure. Unless some supplier has old stock or puts in g tips as I had done, supposedly
there arent any available.
I was there 3 weeks ago and he pulled 2 different part numbers and when the box was opened the nozzles were the same. Pop was different and the spray patterns looked identical to me. Non turbo 1950 psi, turbo 2150 psi.
there arent any available.
I was there 3 weeks ago and he pulled 2 different part numbers and when the box was opened the nozzles were the same. Pop was different and the spray patterns looked identical to me. Non turbo 1950 psi, turbo 2150 psi.
dyoung14
Is getting worn out
why do they have different pressures?
razorback
Full Access Member
pensacoladiesel.com has reman for 22 a piece i believe.
Near as I can figure it is a timing issue, if the fuel injects a bit later it puts more heat in the exhaust to spool the turbo.
The real reason is to reduce emissions with better atomization.
I just checked the manual and pop on turbo injectors is 1900psi.
Similar threads
