Duralift facet pump install pics

[askikr79]

If anyone has a duralift facet pump under the hood, please post a link or a pic.
I am trying to mount it under the hood and I am made two brackets so far but don't like the position the pump is in. I am trying to put it on the passenger side close to the hood springs.

I made a bracket for a coolant filter that will mount next to the alternator. I will wait till I replace the radiator to install the filter.

 

[FORDF250HDXLT]

 

[askikr79]

Thanks for the pic. I didn't know you could mount the pump sideways.

 

[Trying my best]

http://www.youtube.com/watch?v=xpL6J6WldaI&feature=related

It's mounted to the inner plastic fender well with an angle aluminum and reinforced to the metal fender with a bigger angle iron. I think it was made to hold up a self or something. the video does not show the fancy hardware, just the air bubbles in the pump. By the way use thread sealer on the fittings.

good luck

 

[FORDF250HDXLT]

Thanks for the pic. I didn't know you could mount the pump sideways.

"Vertical mounting is preferred to assure maintenance of rated pressures."

rated pressures:
11.5 - 9 PSI

http://www.facet-purolator.com/inde...ent&task=category&sectionid=7&id=17&Itemid=37


rated pressures of replacement lift pump from AZ:
Airtex Master/Fuel Pump
For your 1993 Ford Truck F250 3/4 ton P/U 4WD 7.3L Diesel 8cyl
Part Number: 60278
Maximum Pressure Range (psi): 5.75


so i wasn't concerned much with mounting her vertically.

 

[RLDSL]

When I was running a single pump , I had it in the same location, I had it bolted on a piece of 4x6" aluminum angle bolted to the inner fender. It allowed just enough room to remove the bowl to clean out the screen on the road. Very handy, keep a spray can of brake cleaner in teh tool box and could pop the bowl and clean out the screen and have it back together in a few minutes without getting dirty

 

[askikr79]

Ok. I think ill try mounting mine on itsside. Makes it alot easier