$300 turbo is givin me a headache

[Squeaky_Wheel]

The only reason the uppipe does not work with the zf5 is because the top of the bellhousing on the zf5 sticks out about 1 inch further (towards the back of the truck) than a c6 bellhousing. This may be the same for a t19 but I am not familiar with a t19. To be clear I have a non-gated banks turbo with the uppipe on the drivers side.

 

[Matrix37495]

I have the non-gated banks with a T-19...uppipe also coming up the drivers side.

Does the zf have fins on the back you could grind down?

 

[Squeaky_Wheel]

You could grind down the fins but it still will not be enough. Its really not that hard to build a custom uppipe as long as you can weld and have a sawzall. I just used 2 2 inch 90degree bent pipe, cut off the flange end of the old uppipe and fit them together. I would also recommend a 2inch body lift, it may not look good to some people but it sure helps with fabrication and installation. Take a look at the photos below. I tried to show the diffence in bellhousing depth. I hope this helps. The photos are from google images.

 

[skidoerr]

if it would work on my 91 i'd buy it. will it?

 

[Midwest_Mudder]

im assuming itd work if its an automatic.