Search results
-
'89 F350 - ABS junk system and safety inspections
I finally received my fresh & Ford certified Vin Label sticker from Marti Auto Works (4 months wait time...) and discovered that someone at the DMV along with a previous owner falsified the GVWR numbers on my truck's registration. Registered as 4499KG (9919lbs) which meant it didn't require an...- WMO4IDI
- Thread
- Replies: 5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Electrical adventures thread - I blew or burned out something...
Well, what started out as a fun electrical project turned to crap. My '89 F350 has had lots of mods done to it, mainly a big rig sleeper cab installed & lots of lights... so many unholy electrical splices done under the dash by POs and it bit me in the ****. The two main projects I was working...- WMO4IDI
- Thread
- Replies: 11
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Tachometer wiring from sensor to instrument cluster question.
I've been hunting a tachometer issue since I bought my truck, it's basically dead now. It used to work on and off, changed the sensor on the IP to no avail, a good slap on the dash sometimes helped it give a reading. Before I go looking for a newly used tach on Ebay, I want to fully rewire it...- WMO4IDI
- Thread
- Replies: 4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Priming/bleeding after fuel tank & line overall, can't seem to prime injector lines.
I finished my new fuel tank install, fuel tanks >>> R12T filter >> ACDelco FSV >>> mechanical lift pump. The truck hasn't ran since early october when I got a huge fuel leak before the lift pump & air got in everywhere. That's when I decided to finish the new tanks instead of just fixing the...- WMO4IDI
- Thread
- Replies: 10
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Another fuel system overhaul thread...
In parallel to my PoBoy wmo centrifuge project I posted, I've made 2 custom aluminum fuel tanks & I'm redoing the entire fuel system. I was hoping to get some input from more experienced IDI guys. What my plan is: Driver side tank is clean D2, passenger side is WMO & once my flatbed is built...- WMO4IDI
- Thread
- Replies: 10
- Forum: 6.9L IH & 7.3L IDI Diesels
-
PoBoy centrifuge build
Hey folks, I've been designing a wmo centrifuge setup with the cheapest available materials I can find, luckily I manage a fabrication shop :D The first item I dug up in my junk parts pile, a Johnson treadmill motor, 90V DC, 2.25 hp, 3150 rpm. I needed a controller for it which I found on...- WMO4IDI
- Thread
- centrifuge poboy wvo
- Replies: 5
- Forum: BioDiesel & Alternative Fuels
