Search results
-
99-00 4.10 rear end transplant in my '86?
Hey guys! This 4.10 is up for sale local to me and I'm considering swapping it in so i get better towing capacity... (I need to move my tractor and project vehicles up to another property in the mountains) Rear Axle 4.10 Ratio ID S156E Fits 99-00 FORD F250SD PICKUP 2940597...- danno
- Thread
- Replies: 9
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Changing to a 4.10 rear axle from a newer model truck.
Good evening IDI friends! Found a 4.10 geared rear end in my area, says it’s from a 2000 F250 would I be able to fit this up easily on my ‘86? I’ve worked on a lot of things but never swapped an axle the guys on dirt every day make it look easy… most I can think I would need would be a...- danno
- Thread
- Replies: 3
- Forum: IDI Tech Article
-
Crusty burnt injector
So... Number 7 cylinder had bubbles coming out around the injector, and no matter what I tried I just couldn’t get the return line fitting to stop leaking. I thought it was a bad copper seat/seal so I pulled the injector and it was UGLY. These were “new” injectors from rockauto about 5000...- danno
- Thread
- Replies: 14
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Name the cause of this smokeshow - 6.9IDI+T
So ... I've had this truck for many years as most of you know... Here's what I've done in my quest for more reliability and power: All new lines back to the tank Electric lift pump (fuel pump, facet) New Moose Jr IP New Rockauto GBremanufacturing Injectors <-- my current most likely candidate...- danno
- Thread
- smoke 6.9 idi
- Replies: 58
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Alternator and voltage regulator wiring help
Hey guys and gals.. I’ve been working on the wiring on the battery/charge side and in testing the alternator (which is new’ish) it was not putting out a charge voltage. I started tracing wires back to the voltage regulator and along with some very shoddy splicing I’ve noticed some strange...- danno
- Thread
- Replies: 12
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Y-pipe to up-pipe slip fitting
Hey guys I scrounged up a couple of used turbo “kits” off of eBay for a stock turbo bolt on for the 6.9 in my ‘86. I believe I have all of the parts except the down pipe which I can make. Problem is test fitting all of the hot side piping the y pipe and up pipe have a slip fitting which I...- danno
- Thread
- Replies: 20
- Forum: 6.9L IH & 7.3L IDI Diesels
-
HELP! I ignored y'alls advice and bought a GB Reman IP from RockAuto, screwed?
So i read tons of threads and tech on IP replacement and after deliberating endlessly on the different Moose Pumps from Conestoga, i finally just gave up and bought a lower cost option from RockAuto re manufactured by GB Remanufacturing. Needless to say i'm writing this post because it...- danno
- Thread
- injector pump priming issue remanufactured replacement
- Replies: 12
- Forum: 6.9L IH & 7.3L IDI Diesels
