It was about a two day project. I had to cut and weld most mounts because the front seat mounts where wider then the stock ones. I think im going to bring the drivers seat down another half inch when I take it apart to fix the cloth. The back seats I had to build some L brackets that I welded...
can it be done maybe. Would i do it? No way. I had swapped a 302 and 351 into my bronco II back when it was still a bronco II. The 351 is a little wider and you run into issues with steering, from the steering wheel to the steering box. Then you have the weight of the thing. The 2.9 is...
thanks this is perfect. i noticed that some power goes through the blinker relay and i put an led one in there and that might be messing with it. When i get home i will have to check it out. Thanks again!
I decided to put in my 86 f350 a 97 cummins 12v. I got a nv4500 to go behind it. I bought some pre made motor mounts which i wasnt impressed with sense i had to notch out a piece of them to clear my power steering pump line that runs up to my hydro boost. I also had to notch out a chunk of...
I just got done doing my cummins swap into my 86 f350. I got everything working but the cruise control. It worked before the swap. I swapped over the vacuum dump switch. I adjusted it in all the way in so you cant really see the white part. I did have to put a new speed sensor in and had to...
I been swapping in a 97 cummins into my ford f350 and when i had the engine out i ground the fuel plate and increased the governor springs 2 clicks. I set the timing to 14 degrees i though. I didn't check the rocker arms when doing it but i did check the pin on the side of the pump along with...
thanks for the tips. I was able to get it to act like a normal clutch by feel but haven't started the truck yet so we will see. I took the slave off and pointed it strait down and pushed it in all the way by hand and released. Did it several times and it seemed to have done the trick. Thanks...
activate the slave by hand? I pushed it in and out a couple times when i pulled it back out. I pulled the line off the slave and pumped the clutch till i got a decent amount of fluid each time i pressed it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.