Recent content by NTOLERANCE

  1. NTOLERANCE

    OBS tail gate with finish panel $175

    I could use a set of idi injectors bump http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  2. NTOLERANCE

    R and d stage 1's "new"

    I need a set. Are these quality injectors? Worth the $200 http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  3. NTOLERANCE

    No voltage to FIPL

    Found it. It was the relay. It would carry voltage but not a load. How much current can the ecu pull ? Well It's fixed at any rate.
  4. NTOLERANCE

    No voltage to FIPL

    Ok. The black wire is number 7 which according the the schematic goes to the trans temp sensor. It's never been hooked up since I got the van.
  5. NTOLERANCE

    No voltage to FIPL

    Sorry - been swamped. There is a black wire going to the trans controller. Its been cut out of the harness and there is a blue wire taped to it. This blue wire is wrapped around the left head lamp. I assumed this blue wire was for some sort of extra lighting the PO had. Well its not need to...
  6. NTOLERANCE

    OBS tail gate with finish panel $175

    Bump. Any trades ?? http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  7. NTOLERANCE

    Blue plastic in aod oil pan

    Trans gave up. Any idea what this is?
  8. NTOLERANCE

    OBS tail gate with finish panel $175

    Pretty solid unit. Anyone nearby need one ? One rust spot. Surface rust. Finish panel has a crack
  9. NTOLERANCE

    No voltage to FIPL

    Thanks. Relay is working. Has some corrosion but cleaned it up. Has power coming out. I still have no power to the flpi
  10. NTOLERANCE

    No voltage to FIPL

    Well that was the blower motor relay. Any idea where the teca repay is? http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  11. NTOLERANCE

    No voltage to FIPL

    Think I found it. This looks like the teca power relay? http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  12. NTOLERANCE

    No voltage to FIPL

    My e4od started acting up again I have second and third. I have no pos voltage going to the FIPL. Fuses good. I must've lost a wire connection somewhere this past winter and then it came back. Now it's gone 100%. Anyone have a schematic? I'm going to trace Down wires. 90 E350 club wagon.
  13. NTOLERANCE

    E4od shifting funny

    I meant if I disconnect then reconnect it runs normal for a while. At any rate warmed up enough here for a day. I reset the fipl and cleaned the connections and its running fine. The fuel filter is right above that side of the IP and every filter change soaks the area in fuel/oil. I need to...
  14. NTOLERANCE

    E4od shifting funny

    Some updates. If I disconnect the tps it will run normal untill I shut the truck off. http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
  15. NTOLERANCE

    E4od shifting funny

    I pulled the tps plug off the ip and cleaned it yesterday. Worked fine for about 50 miles. Today not working. It won't down shift. I'm going to probe the tps tonight. http://s30.photobucket.com/component/Download-File?file=%2Falbums%2Fc341%2Fntolerance%2Fviewattachme_zps6b8441e7.jpg
See more

Latest posts

Forum statistics

Threads
91,304
Posts
1,129,963
Members
24,110
Latest member
Lance

Members online

Total: 695 (members: 7, guests: 688)

Share this page

Top