I've been pondering selling my '11 f250 and buying a super nice IDI or Powerstroke. I'm going to put my '11 up for sale tomorrow. If anyone knows of any clean trucks for sale, let me know. Obviously CA is out of the question but i'm not afraid to travel a little.
I'm after a 92-97 F350...
The spacers are to allow for the crazy negative offset of the Humvee wheels. They're the correct 8x6.5 bolt circle pattern for our trucks. I bought the spacers from US Wheel Adapters in Aurora, Colorado. They weren't cheap, but they're nice quality. Be careful buying wheel spacers as they're...
I bought a 2011 superduty a couple years ago almost so the old IDI has been sitting mostly. It was pretty shot in nearly every department so I spruced her up a touch for winter beater duties.
Here's the list of junk I fixed on it.
All new universals everywhere.
Balanced Driveline...
http://grandrapids.craigslist.org/cto/4420847840.html
It's not mine, I just thought it was pretty cool!
Professionally restored 2 years ago. Diesel conversion done at this time. The engine is a 6.9 international that has approximately 100k miles. C-6 Automatic...
I'm looking to sell my truck but don't know what to ask. It's very solid for a Michigan truck. It's an '89 f350 lariat. It has a 7.3 naturally aspriated engine with a c6 automatic transmission. It's 4x4 so it has a bw1353 transfercase and a king pin dana 60 front axle. It has 4.10 gears...
I've had a return line leak for the past week that I was putting off until I had time to replace the Injectors with some BB Codes I got from Russ this past spring. Anyway, I always wondered if the injectors were original; based off of the gray paint on everything. That and the fact that truck...
It's an '89 F-350 lariat with a N/A 7.3, C6 and 4.10 Gears. It's a standard cab long box. King pin Dana 60 up front with manual locking hubs. Transfer case is a bw1356
It has a red interior with a bench seat and fold down arm rest.
NEW PARTS (as of july)
Alpine deck and pioneer...
I might end up going that route, unfortunately. I haven't had any luck with any original ones gas or diesel. Everything here is dissolved junk!
I don't mind doing the grafting... just one more thing to do! The list gets longer every day. yay spot welds! Thanks for the offer though...
So this thing has been through a lot already since I've had it. Actually, I've been through a lot! It started off with a head gasket job, starter, glow plugs and she was running pretty good. I must've put a little over 1000 hard miles on it. The dang thing always smoked from one cylinder...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.