Recent content by BioFarmer93
-
Holley Red are garbage, what else quickly?
Well, I had a Holley Red in the truck for about 2.5 years (I didn't have to fiddle with a pressure restrictor) then a Holley Black for about 6-7 months (Where I DID have to fiddle with a pressure restrictor). Both were loud, until the engine fired, then their sound was lost to the sound of the...- BioFarmer93
- Post #80
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Henry the Ford has been sold..
My garage is too cluttered, and among the clutter are four barrels of used motor oil (one is already filtered and thinned) a centrifuge, 0.05 micron polyester felt filter bags, a farm duty 1hp motor mounted with power steering pump, valves, tubing, fittings, final water-block filter with...- BioFarmer93
- Thread
- Replies: 7
- Forum: 6.9L IH & 7.3L IDI Diesels
-
HENRY is for sale..
Maybe, I'll have to dig around and see.. It's caveman simple and works great.- BioFarmer93
- Post #8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
what is a good A/M electric fuel pump for a 6.9l?
Walbro Industrial E-Lift Pump, FRB-13. Fuel pressure and flow rate are good, Marine rated Coast Guard approved.. Pretty much bullet proof.- BioFarmer93
- Post #18
- Forum: 6.9L IH & 7.3L IDI Diesels
-
HENRY is for sale..
Yeah, that's Henry.. He has 8 new sleeves with less than 5000 miles on the rebuild, starts ridiculously easy but needs a new throttle cable. Everything is in the description except for the H2 system and the tank for the water injection.- BioFarmer93
- Post #6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
HENRY is for sale..
He just sits... I don't need him any longer.- BioFarmer93
- Post #3
- Forum: 6.9L IH & 7.3L IDI Diesels
-
HENRY is for sale..
-And comes with two T2-T3 hybrid turbos, cooler already installed, big box of silicone elbows, clamps, adapters & pieces. Also some O/E parts (if wanted). $2500.00 Jacksonville Florida- BioFarmer93
- Thread
- Replies: 9
- Forum: 6.9L IH & 7.3L IDI Diesels
-
PSD vs IDI fuel economy
Not for a 7.3, you can build a very nice drycell unit for about $300. The burn is faster and specific impulse is improved, so less time to heat the head, cylinder & piston. I have observed NO difference in running temp. Do REAL research and testing like I have before you repeat other people's...- BioFarmer93
- Post #31
- Forum: 6.9L IH & 7.3L IDI Diesels
-
What gauges would you install?
Primary 3 inside- Volts Mechanical Vacuum Mechanical coolant temp On hood- mechanical oil pressure mechanical fuel pressure My gauges are mix n' match, but I'm not too vain about such things, they just have to be accurate and always work. I do have an ammeter inside coming off of a 150 Amp...- BioFarmer93
- Post #21
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Walbro FRB-13-2 6-8 psi 43 gph
It works great, but I had to pull it out because I was hauling gravel and it was mounted in the bed. I'm going to update a few parts on it and reinstall as soon as I can use my feet again, next 2 or 3 weeks hopefully..- BioFarmer93
- Post #17
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Walbro FRB-13-2 6-8 psi 43 gph
Same here, and I run a Goldenrod waterblock filter in front of it to meet warranty requirements. Best pump by far (IMHO)- industrial marine pumps HAVE to be better simply because of their anticipated environment and the lives depending on them. I have it mounted on the passenger side frame rail.- BioFarmer93
- Post #14
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Twin Pyrometers?
I run twin Auber digital's, and can't imagine why anyone would think that only a single one would suffice on a V style engine.. They are so accurate that I can tell you what the temperature outside is just by flicking on the key (if the engine is cold). With a little creativity you can make it...- BioFarmer93
- Post #18
- Forum: 6.9L IH & 7.3L IDI Diesels
-
89 Navistar 7.3 idi----Learner Question
I'll probably catch hell from the other guys about this, but it works.. Disconnect the hot wire to your glow plug controller or however your set up is, just make sure they can't glow. With brake set, trans in neutral and key in run position, take off air cleaner cover and give a little spritz of...- BioFarmer93
- Post #84
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Current radiator recommendations?
I got this three row about 6 years ago, it has worked like a champ the entire time. I checked it over real well the day it got here and was actually impressed with the quality of workmanship. It fit perfectly, so installation was a breeze and it cools well running Fleet Guard and extra SCA's...- BioFarmer93
- Post #39
- Forum: 6.9L IH & 7.3L IDI Diesels
-
My facet mechanical to electric fuel pump conversion review.
Ah, yes- I'd forgotten about the hard line to the I.P.. Mine has been 3/8" diesel rated hose for so long that it completely slipped my mind. In the photo you can see that my setup is completely off the res, so to speak. I would say "custom", but think it should be prettier to call it that. I...- BioFarmer93
- Post #83
- Forum: 6.9L IH & 7.3L IDI Diesels
