trythis
Full Access Member
Working on this 7.3 ID I trying to set the timing I got a new model 3300 diesel timing unit. I got the probe hole cleaned out and install the probe it fits tight.
So I power up the unit and plug in the probe.
I hooked the little transponder up on the number one injection line close to the injector after sanding and cleaning the injection line. Then I hooked the red wire up to power source and the black wire with the clamp I just grounded it to the injection line clean spot.
All I can see to do now is to start the engine turn the function switch to the probe position.
Then I understand I should see the RPM display and the degrees display. The degrees say 0 not flashing the RPM shows a 0 that scans across the little screen.
How long should it take four of the RPM to show up? And I wonder why the degrees read 0?
If you need any pictures or some kind of attached file I can do that just not sure what you all might need thank you for any help
So I power up the unit and plug in the probe.
I hooked the little transponder up on the number one injection line close to the injector after sanding and cleaning the injection line. Then I hooked the red wire up to power source and the black wire with the clamp I just grounded it to the injection line clean spot.
All I can see to do now is to start the engine turn the function switch to the probe position.
Then I understand I should see the RPM display and the degrees display. The degrees say 0 not flashing the RPM shows a 0 that scans across the little screen.
How long should it take four of the RPM to show up? And I wonder why the degrees read 0?
If you need any pictures or some kind of attached file I can do that just not sure what you all might need thank you for any help