-
-
ROCK HARVEY replied to the thread Freeze plug tool.Justin from R&D IDI Performance uses a modified hole saw to convert the block from the disc-style freeze plugs to the cup-style kind... -
ROCK HARVEY replied to the thread IDI marine engine questions.I haven’t dug into it yet since the initial inspection, but I’ll definitely check the piston part numbers to verify whether I can use...
-
Piston Thrust. All the pistons will have to replaced (can't be spun 180 degs due to the Riccardo chamber) as well so the thrust side is...
-
Haha yeah we talked a bit about you, said if I ever need turbo work I was going to go to you. He joked you'd suggest doing a big turbo...
-
ROCK HARVEY replied to the thread Showerhead filter alternative?.I’m 90% certain that the ohms range on the sender/gauge is different on the bullnose trucks than it is on the brick/aero nose ones. I...
-
Just read thru your entire post, and this is why Justin is back to ONLY himself and no employees building, although he told me next time...
-
ROCK HARVEY replied to the thread IDI marine engine questions.I went and picked it up today, and there’s good news and bad news. The good: - The guy had the heads gone through and resurfaced before...
-
So I set the timing, its.... 7... Ish. Went and drove it around the block a few times, I definitely had some residual raw fuel in the...
-
OK got the pump and injectors in the mail today, installed those bad boys, eyeballed the timing when installing the pump and.... NO MORE...
-
Just checked tracking number. Says I'll get everything back on Monday. Well I guess I'll work on the camper instead this weekend. :idiot:
-
ROCK HARVEY replied to the thread Fresh build, smoke, stumped.That is interesting about the required fuel pressure at the pump. The Stanadyne DB2 manual calls for “greater than zero” to 5 psi for a...
-
Well got off the phone with Justin not long ago, he tested the injectors and confirmed one was stuck wide open. He took it apart and...
-
ROCK HARVEY replied to the thread IDI marine engine questions.I reached out to the guy and if all goes well I’ll go pick it up this weekend. I’ll check any part number I find to see how they cross...
-
ROCK HARVEY replied to the thread IDI marine engine questions.That’s what I’m thinking too. This is a really good point, I will try to find out. Thanks for the good points guys, I’m leaning...
-
I came across a 7.3 IDI boat engine locally for $250. The guy is selling it because the water-cooled exhaust manifold cracked and...
-
-
Loading…
-
Loading…
