Latest activity
-
03wr250f reacted to Austin86250's post in the thread 085 better spooling, zf5, and intercooled with
Like.
Ran it up and down the mountains yesterday for a couple hours still checks out I’m giving it a clean bill of health -
I am new to oilburners but I have been lurking for years. I’ve got an ‘85 F250 2wd with a 6.9 and c6. It’s not pretty and has its share... -
Cranking the engine with the Schraeder valve depressed will be a better test for air intrusion. You should have a solid stream of fuel... -
88769bigred replied to the thread 6.9 IDI valve train questions + head gasket job.Well I got some valve guide measurements First thing I did was set my hole gauge to .3775. This is .0055 over my new exhaust valve...
-
-
88769bigred reacted to rreegg's post in the thread 6.9 IDI valve train questions + head gasket job with Like.
Is a weld nut a specialty part or just a nut that’s welded to allow bolt to thread? I did an idi water pump this past winter but never...
-
Waiting on parts... I snugged up some of the hard lines and used a vacuum pump kit to try to get air out of the lines. I assume the... -
Olds64 replied to the thread 1987 6.9 IDI Losing Prime Overnight.Cranking the engine with the Schraeder valve depressed will be a better test for air intrusion. You should have a solid stream of fuel...
-
Ole BlackBetty replied to the thread Maxtow gauges.Ok just got my gauges installed and either something is wrong with my get gauge or I don’t know how to read it . It looks to me like it... -
-
For example, my injectors he built one got stuck open directly after install causing mad fuel knock. He had me ship them back and got... -
Thanks all for the input! Just discovered that the hard line into my lift pump is leaking (pic attached). The vacuum pump was replaced... -
Waiting on parts... I snugged up some of the hard lines and used a vacuum pump kit to try to get air out of the lines. I assume the... -
Jesus Freak reacted to Rdnck84_03's post in the thread Alternator mount tensioner bracket ... hose clip? (6.9) with Like.
I use a large crescent wrench on the square lug that the top bolt screws into. James
-
Jesus Freak reacted to Clb's post in the thread Alternator mount tensioner bracket ... hose clip? (6.9) with Like.
Those are the sorta stuff I always go to the wreckin yard for, they lasted longer than the chiacom replacement will.
-
idiBen replied to the thread 1987 6.9 IDI Losing Prime Overnight.Waiting on parts... I snugged up some of the hard lines and used a vacuum pump kit to try to get air out of the lines. I assume the...
-
-
If it help, I have a Napa pump on my truck, but it also is from 2011, quality might be different.
Latest posts
-
-
-
-
Help....Need a New Diesel Filler Neck for the MidShip/Side Tank
- Latest: Ole BlackBetty
